Re: [Xen-devel] pv_ops dom0 testing

["Todd Deshane" <deshantm@xxxxxxxxx>]

On Sat, Nov 29, 2008 at 4:38 PM, Aviv Grafi <aviv@xxxxxxxxxxxx> wrote:
> I had the same issue few days ago: try to boot the vmlinux (and not
> vmlinuz) image that you can find in your kernel build directory.
> You can verify that you are booting the right image file by using the
> readelf tool.
>

Thanks for the tip Aviv. That got me a little farther.

The debug output now ends with:
(XEN) ioapic_guest_write: apic=0, pin=4, old_irq=4, new_irq=4
(XEN) ioapic_guest_write: old_entry=000009f1, new_entry=000189f1
(XEN) ioapic_guest_write: Attempt to modify IO-APIC pin for in-use IRQ!

Full output attached.

Do I need to either modify more of the default kernel settings or pass
some more options to Xen or the dom0 kernel?

When running non-debug mode, I don't see any dom0 output on the screen,.
I tried a few different console= lines
tty0, xvc0, hvc0.... but only Xen hypervisor output ending with:
(XEN)  Xen is relinquishing VGA console

Can someone post a working .config and grub config and/or the
instructions to get to that point beyond the default setup?

Cheers,
Todd

Attachment: xenboot.out2
Description: Binary data

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel