Re: [Xen-devel] pv_ops dom0 and kernel console output problem

["Todd Deshane" <deshantm@xxxxxxxxx>]

On Mon, Dec 29, 2008 at 12:02 PM, Pasi Kärkkäinen <pasik@xxxxxx> wrote:
> On Mon, Dec 29, 2008 at 11:55:26AM -0500, Todd Deshane wrote:
>> Did you add an hvc console to the runlevel?
>>
>
> Actually, no, I didn't add hvc console.. That's a stupid mistake from me.
> Thanks for pointing that out.
>
> Then again, shouldn't I see kernel messages when it boots up?
>

Is it not writing to /var/log/dmesg|syslog|messages?

Here is some more patches for the hvc stuff that are relatively recent:
http://xen.markmail.org/search/?q=hvc%20list%3Axen-devel#query:hvc%20list%3Axen-devel+page:1+mid:vtzvf44kzapb2vxa+state:results


> I can only see Xen hypervisor console messages.. nothing from dom0 kernel..
>
It does a switch over to the other console.
I would expect xm dmesg to give the xen messages and dmesg to give the
dom0 messages. Could you be losing it when sending it to the serial console?

Adding the hvc console worked for me, if I recall correctly. We should add that
to the wiki as well (if it isn't there already).

Cheers,
Todd

-- 
Todd Deshane
http://todddeshane.net
http://runningxen.com

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel