RE: [Xen-devel] HVM guest sees two NICs even though just one vif configured

["Fischer, Anna" <anna.fischer@xxxxxx>]

> Subject: RE: [Xen-devel] HVM guest sees two NICs even though just one
> vif configured
> 
> On Thu, 6 Aug 2009, Fischer, Anna wrote:
> > > Subject: Re: [Xen-devel] HVM guest sees two NICs even though just
> one
> > > vif configured
> > >
> > > On 06/08/2009 10:32, "Fischer, Anna" <anna.fischer@xxxxxx> wrote:
> > >
> > > > For me this does not sound right. If I configure my guest with
> only a
> > > single
> > > > NIC in the configuration file, then there should not be any way
> for
> > > the guest
> > > > to set up and use two NICs at the same time.
> > > >
> > > > Is this a known issue? How is this supposed to be handled?
> > >
> > > I think it's deliberate, to allow install of an OS with emulated
> > > driver,
> > > followed by switchover to PV drivers, wth no need for config
> changes.
> >
> > I assumed that was the reason behind this. However, a switchover
> would need to guarantee that a guest cannot use two NICs at the same
> time, doesn't it? Because otherwise the guest can send out of two
> separate devices at the same time and it could cause unexpected
> behaviour unless it is explicitly prevented at the backends in Dom0,
> e.g. through filtering or anti-spoofing I guess.
> >
> 
> I more recent qemu allows the pv drivers in the guest to disconnect the
> emulated devices to avoid these problems.

I am not too confident with having to rely on the guest to make such a 
disconnect happen. Is there no way to do this in Xen/Dom0?

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel