[Xen-devel] DL120G5 specific problem

[Andrey Korolyov <andrey@xxxxxxx>]

Hi,

I am experiencing strange problem about two old proliants usingÂ2.6.32-5-xen-amd64 andÂxen-hypervisor-4.0-amd64-4.0.1-1 from squeeze repoÂwith same hw config. They freezes on reboot(exactly, after printing 'restarting system') and may be booted up again only over ilo or by hands.

Here is parts of dmi info:

Handle 0x0000, DMI type 0, 24 bytes

BIOS Information

ÂÂ Â Â ÂVendor: HP

ÂÂ Â Â ÂVersion: O22 ÂÂ

ÂÂ Â Â ÂRelease Date: 11/13/2008

ÂÂ Â Â ÂAddress: 0xE6820

ÂÂ Â Â ÂRuntime Size: 104416 bytes

ÂÂ Â Â ÂROM Size: 2048 kB

Handle 0x0002, DMI type 2, 10 bytes

Base Board Information

ÂÂ Â Â ÂManufacturer: Wistron Corporation

ÂÂ Â Â ÂProduct Name: ProLiant DL120 G5

ÂÂ Â Â ÂVersion: Â Â ÂNA

ÂÂ Â Â ÂSerial Number: 0123456789

As i guess problem comes with device which using proprietary firmware Dell Broadcom NetXtreme II Dual Port:

ââ01:00.0 Ethernet controller: Broadcom Corporation NetXtreme II BCM5709 Gigabit Ethernet (rev 20)

01:00.1 Ethernet controller: Broadcom Corporation NetXtreme II BCM5709 Gigabit Ethernet (rev 20)

because third server with same config but without this card reboots well.Â

The servers was old and cards was relatively old so this report may be not useful as well.

Thanks!

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel