[Xen-devel] [PATCH]: Update gdbsx README

[Mukesh Rathor <mukesh.rathor@xxxxxxxxxx>]

Signed-off-by: Mukesh Rathor <mukesh.rathor@xxxxxxxxxx>

diff -r 4e108cf56d07 tools/debugger/gdbsx/README
--- a/tools/debugger/gdbsx/README       Mon Dec 27 08:00:09 2010 +0000
+++ b/tools/debugger/gdbsx/README       Mon Dec 27 15:09:44 2010 -0800
@@ -13,9 +13,6 @@
 
 
 USAGE:
-   - boot with gdbsx enabled hypervisor (eg, on OVM: xen-64bit-debug.gz)
-   - copy gdbsx binary to the dom0 (assume hostname is "dom0"), then:
-
    USAGE 1:
    - dom0> gdbsx -c 1 64 : displays VCPU contexts for 64bit guest with domid 1
 
@@ -59,16 +56,6 @@
    - make sure firewall is disabled on dom0 if running gdb on a different host.
    - Must be at least gdb version 6.5-16.x to debug el5 kernels.
 
-BUILD: (if you don't have access to binary):
-   - first compile the hypervisor: xen> make gdbsx=y
-         To have both kdb and gdbsx, xen> make kdb=y gdbsx=y
-        (NOTE: kdb is not required for gdbsx)
-   - install the hypervisor and reboot
-   - now go to, tools/debugger/gdbsx and do make
-     On 32bit system, a 32bit binary will be built with support for both 32
-     and 64bit guests. On 64bit system, a 64bit binary will be built with 
-     support for both.
-
 
 Mukesh Rathor
 Oracle Corporation,
@@ -89,12 +76,12 @@
        set $task = $tasks
        set $task_entry = (struct task_struct *)((unsigned long)$task - $offset)
        printf "Pointer       PID      Command\n"
-       printf "%-14p%-9d%s\n", $task_entry, $task_entry->pid, $task_entry->comm
+       printf "%p %-9d%s\n", $task_entry, $task_entry->pid, $task_entry->comm
        set $task = $task->next
        while $task != $tasks
                set $task_entry = (struct task_struct *)((unsigned long)$task - 
$offset)
                if ($task_entry->pid) != 0
-                       printf "%-14p%-9d%s\n", $task_entry, $task_entry->pid, 
$task_entry->comm
+                       printf "%p %-9d%s\n", $task_entry, $task_entry->pid, 
$task_entry->comm
                end
                set $task = $task->next
        end

Attachment: diff.out
Description: Binary data

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel