Re: [Xen-devel] Xen doesn't boot on grub2 or xend doesn't start

[Pasi Kärkkäinen <pasik@xxxxxx>]

On Sun, Apr 22, 2012 at 04:21:10PM -0300, José Eduardo França wrote:
>    hi guys,
> 

Hello,

>    It's my first time here and in a mailing lists, I only participated in
>    forums before. Please, If I make a mistake you should advise me. Let's go!
> 
>    I was reading "xencommons not start" in a Remus Forum in order to install
>    Remus.
>    Well* I followed the tutorial
>    <[1]http://remusha.wikidot.com/configuring-and-installing-remus>, I reboot
>    in xen_unstable and I had a error message:
> 
>    error: couldn't open file
>    error: you need to load the multiboot kernel first
> 
>    then I redid tutorial after "Adapt Grub" and in a moment I do command:
> 
>    # /etc/init.d/xend start
>    xencommons should be started first.
> 
>    but I had done "/etc/init.d/xencommons start" before and no error message
>    returned !!!???
> 
>    I also tried insert modules manually (coz in other mailing list said to
>    put some modules - see my setups after this mail) but I had:
> 
>    # modprobe xen-evtchn
>    FATAL: Module xen_evtchn not found.
> 

So xen event channel support is not compiled as a module? 
is it enabled at all in your dom0 kernel config? 

http://wiki.xen.org/wiki/Xen_Common_Problems#Starting_xend_fails.3F

-- Pasi



_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel