[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Xen-devel] [PATCH] docs: document "ucode=" hypervisor command line option



On Mon, 2012-09-10 at 10:39 +0100, Jan Beulich wrote:
> Signed-off-by: Jan Beulich <jbeulich@xxxxxxxx>

Acked and applied. Thanks.

Can/will you take this for 4.2.0 too?

> 
> --- a/docs/misc/xen-command-line.markdown
> +++ b/docs/misc/xen-command-line.markdown
> @@ -785,6 +785,19 @@ Specify the per-cpu trace buffer size in
>  > `= unstable | skewed`
>  
>  ### ucode
> +> `= <integer>`
> +
> +Specify the CPU microcode update blob module index. When positive, this
> +specifies the n-th module (in the GrUB entry, zero based) to be used
> +for updating CPU micrcode. When negative, counting starts at the end of
> +the modules in the GrUB entry (so with the blob commonly being last,
> +one could specify `ucode=-1`). Note that the value of zero is not valid
> +here (entry zero, i.e. the first module, is always the Dom0 kernel
> +image). Note further that use of this option has an unspecified effect
> +when used with xen.efi (there the concept of modules doesn't exist, and
> +the blob gets specified via the `ucode=<filename>` config file/section
> +entry; see [EFI configuration file description](efi.html)).
> +
>  ### unrestricted\_guest
>  > `= <boolean>`
>  
> 
> 
> 



_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel


 


Rackspace

Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.