[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Xen-devel] [PATCHv3] QEMU(upstream): Disable xen's use of O_DIRECT by default as it results in crashes.



On 03/19/2013 10:43 AM, Paolo Bonzini wrote:
Even for successful migration, it would also be bad for downtime (QEMU
isn't exactly lightning-fast to start).  And even if failure weren't
catastrophic, it would be a pity to transfer a few gigs of memory and
then find out that QEMU isn't present in the destination. :)

Well, if qemu isn't present at the destination, that's definitely user
error. :-)  In any case, I know that he migrate can resume if it
fails, so I suspect that the qemu is just paused on the sending side
until the migration is known to complete.  As long as the last write
was flushed to the NFS server before the receiver opens the file, we
should be safe.

Note that the close really must happen before the next open.  Otherwise
the file metadata might not be up-to-date on the destination, too.

By "file metadata" I assume you mean "metadata about the virtual disk within the file", not "metadata about the file within the filesystem", right? That's good to know, I'll keep that in mind.

Even if it's true that at the moment qemu doesn't write the file metadata until it closes the file, that just means we'd have to add a hook to the callback to save qemu state, to sync the metadata at that point, right? (This may in fact already be done; I'm more or less completely unfamiliar with the qemu side of save/restore.)

 -George

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel


 


Rackspace

Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.