[Xen-devel] çåï Re: [PATCH] xen/arm: add OMAP5432 UART support for early_printk

["Bamvor Jian Zhang" <bjzhang@xxxxxxxx>]

>
>On Jun 27, 2013, at 4:22 PM, Ian Campbell <Ian.Campbell@xxxxxxxxxx> wrote:
>
>> On Thu, 2013-06-27 at 15:20 +0800, Chen Baozi wrote:
>>> To enable it, add "CONFIG_EARLY_PRINTK := omap5432" to Config.mk
>> 
>> From the register offsets this looks like it might be a somewhat 8250
>> compatible UART logic block?
>From TI's data manual, it is said this is a 16C750 compatible UART. So could 
>it be called an 9250 compatible UART?
>
>> 
>> Bamvor also implemented a driver for an 8250 like device on the
>> sun6i[0]. Rather than having multiple drivers for similar platforms I
>> asked him to produce a single configurable 8250 driver. Perhaps you
>> could work together to make sure this works for you both?
>Sure, it is OK for me.
great. i could update my patch and support both sun6i and omap5432. 
>
>> 
>> Thanks,
>> Ian.
>> 
>> [0] see "xen/arm: introduce Allwinner sun6i SOC basic support"
>> <1370004814-30686-3-git-send-email-bjzhang@xxxxxxxx>.
>> 
>>> +ifeq ($(CONFIG_EARLY_PRINTK), omap5432)
>>> +EARLY_PRINTK_INC := omap
>>> +EARLY_PRINTK_INIT_UART := y
>> 
>> Does your bootloader not setup the UART? Preferably we would simply
>> inherit that setup (avoids more code and mismatched baud rate etc).
>Yes, it does. I thought re-initilization is necessary and found that is also 
>ok to inherit the u-boot setup just after finishing the patch. Well, in this 
>case, things are much easier :-)
>
>Thanks,
>
>Baozi
>
>> 
>> Ian.
>> 






_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel