Re: [Xen-devel] [PATCH 1/1] xen/netback: correctly calculate required slots of skb.

[annie li <annie.li@xxxxxxxxxx>]

On 2013-7-10 0:16, Wei Liu wrote:
> On Tue, Jul 09, 2013 at 02:15:20PM +0800, Annie Li wrote:
> > When counting required slots for skb, netback directly uses DIV_ROUND_UP to get
> > slots required by header data. This is wrong when offset in the page of header
> > data is not zero, and is also inconsistent with following calculation for
> > required slot in netbk_gop_skb.
> >
> > In netbk_gop_skb, required slots are calculated based on offset and len in page
> > of header data. It is possible that required slots here is larger than the one
> > calculated in earlier netbk_count_requests. This inconsistency directly results
> > in rx_req_cons_peek and xen_netbk_rx_ring_full judgement are wrong.
> >
> > Then it comes to situation the ring is actually full, but netback thinks it is
> > not and continues to create responses. This results in response overlaps request
> > in the ring, then grantcopy gets wrong grant reference and throws out error,
> > for example "(XEN) grant_table.c:1763:d0 Bad grant reference 2949120", the
> > grant reference is invalid value here. Netback returns XEN_NETIF_RSP_ERROR(-1)
> > to netfront when grant copy status is error, then netfront gets rx->status
> > (the status is -1, not really data size now), and throws out error,
> > "kernel: net eth1: rx->offset: 0, size: 4294967295". This issue can be 
> > reproduced
> > by doing gzip/gunzip in nfs share with mtu = 9000, the guest would panic after
> > running such test for a while.
> >
> > This patch is based on 3.10-rc7.
> >
> > Signed-off-by: Annie Li <annie.li@xxxxxxxxxx>
> > ---
> >   drivers/net/xen-netback/netback.c |   97 +++++++++++++++++++++++++-----------
> >   1 files changed, 67 insertions(+), 30 deletions(-)
> >
> > diff --git a/drivers/net/xen-netback/netback.c 
> > b/drivers/net/xen-netback/netback.c
> > index 8c20935..7ff9333 100644
> > --- a/drivers/net/xen-netback/netback.c
> > +++ b/drivers/net/xen-netback/netback.c
> > @@ -359,51 +359,88 @@ static bool start_new_rx_buffer(int offset, unsigned long 
> > size, int head)
> >    * the guest. This function is essentially a dry run of
> >    * netbk_gop_frag_copy.
> >    */
> Just to be clear, now the above comment applies to your new function,
> right?
Oh, this should apply to xen_netbk_count_skb_slots instead of this one,

> > -unsigned int xen_netbk_count_skb_slots(struct xenvif *vif, struct sk_buff *skb)
> > +static void netbk_get_slots(struct xenvif *vif, struct sk_buff *skb,
> A better name would be netbk_count_slots because it doesn't actually
> acquire any slots.
OK, this looks fine.

> And you can make it return the slot count and adds that to the total
> number of slots in the caller, as this function doesn't seem to rely on
> previous count so there is not much point passing in *count.
Correct!

> > +                           struct page *page, int *copy_off,
> > +                           unsigned long size, unsigned long offset,
> > +                           int *head, int *count)
> >   {
> > -       unsigned int count;
> > -       int i, copy_off;
> > +       unsigned long bytes;
> >   
> > -	count = DIV_ROUND_UP(skb_headlen(skb), PAGE_SIZE);
> > +       /* Data must not cross a page boundary. */
> > +       BUG_ON(size + offset > PAGE_SIZE<<compound_order(page));
> >   
> > -	copy_off = skb_headlen(skb) % PAGE_SIZE;
> > +       /* Skip unused frames from start of page */
> > +       page += offset >> PAGE_SHIFT;
> > +       offset &= ~PAGE_MASK;
> >   
> > -	if (skb_shinfo(skb)->gso_size)
> > -               count++;
> > +       while (size > 0) {
> > +               BUG_ON(offset >= PAGE_SIZE);
> > +               BUG_ON(*copy_off > MAX_BUFFER_OFFSET);
> >   
> > -	for (i = 0; i < skb_shinfo(skb)->nr_frags; i++) {
> > -               unsigned long size = skb_frag_size(&skb_shinfo(skb)->frags[i]);
> > -               unsigned long offset = skb_shinfo(skb)->frags[i].page_offset;
> > -               unsigned long bytes;
> > +               bytes = PAGE_SIZE - offset;
> >   
> > -		offset &= ~PAGE_MASK;
> > +               if (bytes > size)
> > +                       bytes = size;
> >   
> > -		while (size > 0) {
> > -                       BUG_ON(offset >= PAGE_SIZE);
> > -                       BUG_ON(copy_off > MAX_BUFFER_OFFSET);
> > +               if (start_new_rx_buffer(*copy_off, bytes, *head)) {
> > +                       *count = *count + 1;
> > +                       *copy_off = 0;
> > +               }
> >   
> > -			bytes = PAGE_SIZE - offset;
> > +               if (*copy_off + bytes > MAX_BUFFER_OFFSET)
> > +                       bytes = MAX_BUFFER_OFFSET - *copy_off;
> >   
> > -			if (bytes > size)
> > -                               bytes = size;
> > +               *copy_off += bytes;
> >   
> > -			if (start_new_rx_buffer(copy_off, bytes, 0)) {
> > -                               count++;
> > -                               copy_off = 0;
> > -                       }
> > +               offset += bytes;
> > +               size -= bytes;
> >   
> > -			if (copy_off + bytes > MAX_BUFFER_OFFSET)
> > -                               bytes = MAX_BUFFER_OFFSET - copy_off;
> > +               /* Next frame */
> > +               if (offset == PAGE_SIZE && size) {
> > +                       BUG_ON(!PageCompound(page));
> > +                       page++;
> > +                       offset = 0;
> > +               }
> >   
> > -			copy_off += bytes;
> > +               if (*head)
> This seems to differ from netbk_gop_frag_copy. In that function it's
> like
>
>      if (*head && skb_shinfo(skb)->gso_size && !vif->gso_prefix)
Sorry, my original patch is based on older version which does not have 
this, need to change that.
Thanks
Annie
> Wei.
>
> > +                       *count = *count + 1;
> > +               *head = 0; /* There must be something in this buffer now. */
> > +       }
> > +}
> > +
> > +unsigned int xen_netbk_count_skb_slots(struct xenvif *vif, struct sk_buff *skb)
> > +{
> > +       int i, copy_off = 0;
> > +       int nr_frags = skb_shinfo(skb)->nr_frags;
> > +       unsigned char *data;
> > +       int head = 1;
> > +       unsigned int count = 0;
> >   
> > -			offset += bytes;
> > -                       size -= bytes;
> > +       if (skb_shinfo(skb)->gso_size)
> > +               count++;
> >   
> > -			if (offset == PAGE_SIZE)
> > -                               offset = 0;
> > -               }
> > +       data = skb->data;
> > +       while (data < skb_tail_pointer(skb)) {
> > +               unsigned int offset = offset_in_page(data);
> > +               unsigned int len = PAGE_SIZE - offset;
> > +
> > +               if (data + len > skb_tail_pointer(skb))
> > +                       len = skb_tail_pointer(skb) - data;
> > +
> > +               netbk_get_slots(vif, skb, virt_to_page(data), &copy_off,
> > +                               len, offset, &head, &count);
> > +               data += len;
> > +       }
> > +
> > +       for (i = 0; i < nr_frags; i++) {
> > +               netbk_get_slots(vif, skb,
> > +                               skb_frag_page(&skb_shinfo(skb)->frags[i]),
> > +                               &copy_off,
> > +                               skb_frag_size(&skb_shinfo(skb)->frags[i]),
> > +                               skb_shinfo(skb)->frags[i].page_offset,
> > +                               &head, &count);
> >         }
> > +
> >         return count;
> >   }
> >   
> > --
> > 1.7.3.4
> >
> > --
> > To unsubscribe from this list: send the line "unsubscribe netdev" in
> > the body of a message to majordomo@xxxxxxxxxxxxxxx
> > More majordomo info at  http://vger.kernel.org/majordomo-info.html

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel