Re: [Xen-devel] [PATCH] xen/arm: Initialize PERCPU variables at the beginning of start_xen

[Tim Deegan <tim@xxxxxxx>]

At 18:01 +0100 on 24 Jul (1374688896), Julien Grall wrote:
> PERCPU variables rely on HTPIDR (TPIDR_EL2) which is in an unknown state when
> a processor boot.
> 
> For the boot CPU, the first use of PERCPU is in setup_pagetables. So
> initialize PERCPU and set the processor ID before.
> 
> Signed-off-by: Julien Grall <julien.grall@xxxxxxxxxx>

Acked-by: Tim Deegan <tim@xxxxxxx>

> ---
>  xen/arch/arm/setup.c |    5 +++--
>  1 file changed, 3 insertions(+), 2 deletions(-)
> 
> diff --git a/xen/arch/arm/setup.c b/xen/arch/arm/setup.c
> index 2f9fdc8..1ec5e38 100644
> --- a/xen/arch/arm/setup.c
> +++ b/xen/arch/arm/setup.c
> @@ -428,6 +428,9 @@ void __init start_xen(unsigned long boot_phys_offset,
>  
>      setup_cache();
>  
> +    percpu_init_areas();
> +    set_processor_id(0); /* needed early, for smp_processor_id() */
> +
>      smp_clear_cpu_maps();
>  
>      device_tree_flattened = (void *)BOOT_MISC_VIRT_START
> @@ -458,8 +461,6 @@ void __init start_xen(unsigned long boot_phys_offset,
>      gic_init();
>      make_cpus_ready(cpus, boot_phys_offset);
>  
> -    percpu_init_areas();
> -    set_processor_id(0); /* needed early, for smp_processor_id() */
>      set_current((struct vcpu *)0xfffff000); /* debug sanity */
>      idle_vcpu[0] = current;
>  
> -- 
> 1.7.10.4
> 
> 
> _______________________________________________
> Xen-devel mailing list
> Xen-devel@xxxxxxxxxxxxx
> http://lists.xen.org/xen-devel

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel