[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Xen-devel] which branch should be used as dom0 on arndale



2013/10/30 mail fetch <fetchmail.0104@xxxxxxxxx>
Hi Julien,

I found there are lots of branches under linux-arm.git. Xen wiki
recommends to use branch arndale. But i found it lacks of the
following configuration in dts file which is exist in branch
arndale-dom0-3.10. Should i use arndale or arndale-dom0-3.10 as dom0?
Can Xen boot up without those configuration?

chosen {
                bootargs = "dom0_mem=256M sync_console console=dtuart
dtuart=serial2 earlyprintk=xen";
                xen,dom0-bootargs = "console=hvc0,115200n8
earlyprintk=xen debug ignore_loglevel psci=enable clk_ignore_unused
root=/dev/mmcblk1p2";
                modules {
                        module@0 {
                                compatible = "xen,linux-zimage",
"xen,multiboot-module";
                                reg = <0x60000000 0x500000>;
                        };
                };
        };

--
best regards
Mail

Any ideas?

--
best regards
Mail
_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel

 


Rackspace

Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.