[Xen-devel] [PATCH 00/15] xen: arm initial support for xgene arm64 platform

[Ian Campbell <Ian.Campbell@xxxxxxxxxx>]

Damnit. Missed the --dry-run... Oh well, the patches are actually
correct I think.

The 00/15 mail would have contained:

This addresses the previous review.

In particular it drops the RFC from a couple of patches and replaces the
HACKs with clean solutions.

A==acked. H==replaces a HACK. R==release acked. r==might be release
akced but George wasn't 100% explicit.

  R xen: arm64: Add 8250 earlyprintk support
A R xen: arm64: Add Basic Platform support for APM X-Gene Storm.
A R xen: arm64: Add APM implementor id to processor implementers.
 H  xen: arm: add a quirk to handle platforms with unusual GIC layout
A   xen: arm: allow platform code to select dom0 event channel irq
 H  xen: arm64: Map xgene PCI memory regions and interrupts to dom0.
A R xen: arm: include ns16550 driver on arm64 too
A r xen: arm: early logging of command line
  r xen: arm: Handle cpus nodes with #address-cells > 1
  R xen: arm: Make register bit definitions unsigned.
A R xen: arm: explicitly map 64 bit release address
  R xen: arm: enable synchronous console while starting secondary CPUs
  R xen: arm: Add debug keyhandler to dump the physical GIC state.
A R xen: arm: improve early memory map readability
  r xen: arm: handle 40-bit addresses in the p2m



_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel