[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Xen-devel] [RFC v2 2/4] net: enables interface option to skip IP



On Mon, Feb 17, 2014 at 12:23 PM, Dan Williams <dcbw@xxxxxxxxxx> wrote:
> On Fri, 2014-02-14 at 18:59 -0800, Luis R. Rodriguez wrote:
>> From: "Luis R. Rodriguez" <mcgrof@xxxxxxxx>
>>
>> Some interfaces do not need to have any IPv4 or IPv6
>> addresses, so enable an option to specify this. One
>> example where this is observed are virtualization
>> backend interfaces which just use the net_device
>> constructs to help with their respective frontends.
>>
>> This should optimize boot time and complexity on
>> virtualization environments for each backend interface
>> while also avoiding triggering SLAAC and DAD, which is
>> simply pointless for these type of interfaces.
>
> Would it not be better/cleaner to use disable_ipv6 and then add a
> disable_ipv4 sysctl, then use those with that interface?

Sure, but note that the both disable_ipv6 and accept_dada sysctl
parameters are global. ipv4 and ipv6 interfaces are created upon
NETDEVICE_REGISTER, which will get triggered when a driver calls
register_netdev(). The goal of this patch was to enable an early
optimization for drivers that have no need ever for ipv4 or ipv6
interfaces.

Zoltan has noted though some use cases of IPv4 or IPv6 addresses on
backends though, as such this is no longer applicable as a
requirement. The ipv4 sysctl however still seems like a reasonable
approach to enable optimizations of the network in topologies where
its known we won't need them but -- we'd need to consider a much more
granular solution, not just global as it is now for disable_ipv6, and
we'd also have to figure out a clean way to do this to not incur the
cost of early address interface addition upon register_netdev().

Given that we have a use case for ipv4 and ipv6 addresses on
xen-netback we no longer have an immediate use case for such early
optimization primitives though, so I'll drop this.

> The IFF_SKIP_IP seems to duplicate at least part of what disable_ipv6 is
> already doing.

disable_ipv6 is global, the goal was to make this granular and skip
the cost upon early boot, but its been clarified we don't need this.

   Luis

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel


 


Rackspace

Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.