Re: [Xen-devel] [PATCH v9 3/7] xen/arm: Add support for GIC v3

[Ian Campbell <Ian.Campbell@xxxxxxxxxx>]

On Fri, 2014-09-05 at 01:27 +0100, Stefano Stabellini wrote:
> On Thu, 4 Sep 2014, vijay.kilari@xxxxxxxxx wrote:
> > From: Vijaya Kumar K <Vijaya.Kumar@xxxxxxxxxxxxxxxxxx>
> > 
> > Add support for GIC v3 specification System register access(SRE)
> > is enabled to access cpu and virtual interface registers based
> > on kernel GICv3 driver.
> > 
> > This patch adds only basic v3 support.
> > Does not support Interrupt Translation support (ITS)
> > 
> > Signed-off-by: Vijaya Kumar K <Vijaya.Kumar@xxxxxxxxxxxxxxxxxx>
> 
> [...]
> 
> > +static void gicv3_irq_set_affinity(struct irq_desc *desc, const cpumask_t 
> > *mask)
> > +{
> > +    unsigned int cpu;
> > +    uint64_t affinity;
> > +
> > +    ASSERT(!cpumask_empty(mask));
> > +
> > +    spin_lock(&gicv3.lock);
> > +
> > +    cpu = gicv3_get_cpu_from_mask(mask);
> > +    affinity = gicv3_mpidr_to_affinity(cpu);
> > +    /* Make sure we don't broadcast the interrupt */
> > +    affinity &= ~GICD_IROUTER_SPI_MODE_ANY;
> 
> I would like an ASSERT(affinity != 0);

Should the v2 code do the same then?

There is no way that this value can be controlled by the guest then?

> 
> Other than that:
> 
> Acked-by: Stefano Stabellini <stefano.stabellini@xxxxxxxxxxxxx>
> 



_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel