[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] Re: [Xen-devel] [PATCH v3] PCI: Add guard to avoid mapping a invalid msix base address
[+cc Jan] On Thu, Jan 29, 2015 at 11:54:43AM +0800, Yijing Wang wrote: > Sometimes, a pci bridge device BAR was not assigned > properly. After we call pci_bus_assign_resources(), the > resource of the BAR would be reseted. So if we try to > enable msix for this device, it will map a invalid > resource as the msix base address, and a warning call trace > will report. > > pci_bus_assign_resources() > __pci_bus_assign_resources() > pbus_assign_resources_sorted() > __assign_resources_sorted() > assign_requested_resources_sorted() > pci_assign_resource() -->fail > reset_resource() > -->res->start/end/flags = 0 > > pcie_port_device_register() > init_service_irqs() > pcie_port_enable_msix() > ... > msix_capability_init() > msix_map_region() > phys_addr = > pci_resource_start(dev, bir) + table_offset; > If BAR(index=bir) was not assign properly, pci_resource_start(dev, bir) > here would return 0, so phys_addr is a invalid physical > address of msix. > > [ 43.094087] ------------[ cut here ]------------ > [ 43.097418] WARNING: CPU: 1 PID: 1800 at arch/arm64/mm/ioremap.c:58 > __ioremap_caller+0xd4/0xe8() > ... > [ 43.121694] CPU: 1 PID: 1800 Comm: insmod Tainted: G O 3.16.0 #5 > [ 43.127374] Call trace: > [ 43.128522] [<ffffffc0000891d4>] dump_backtrace+0x0/0x130 > [ 43.132637] [<ffffffc000089314>] show_stack+0x10/0x1c > [ 43.136402] [<ffffffc0004db040>] dump_stack+0x74/0x94 > [ 43.140166] [<ffffffc0000986f8>] warn_slowpath_common+0x8c/0xb4 > [ 43.144804] [<ffffffc0000987e4>] warn_slowpath_null+0x14/0x20 > [ 43.149266] [<ffffffc000095474>] __ioremap_caller+0xd0/0xe8 > [ 43.153555] [<ffffffc000095498>] __ioremap+0xc/0x18 > [ 43.157145] [<ffffffc0002cc62c>] pci_enable_msix+0x238/0x44c > [ 43.161521] [<ffffffc0002cc874>] pci_enable_msix_range+0x34/0x80 > [ 43.166243] [<ffffffc0002c946c>] pcie_port_device_register+0x104/0x480 > [ 43.171491] [<ffffffc0002c99f8>] pcie_portdrv_probe+0x38/0xa0 > [ 43.175952] [<ffffffc0002bd6c8>] pci_device_probe+0x78/0xd4 > [ 43.180238] [<ffffffc00030e68c>] really_probe+0x6c/0x22c > [ 43.184265] [<ffffffc00030e8a8>] __device_attach+0x5c/0x6c > [ 43.188466] [<ffffffc00030cb68>] bus_for_each_drv+0x50/0x94 > [ 43.192755] [<ffffffc00030e5fc>] device_attach+0x9c/0xc0 > [ 43.196780] [<ffffffc0002b4c54>] pci_bus_add_device+0x38/0x80 > [ 43.201243] [<ffffffc0002b5064>] pci_bus_add_devices+0x4c/0xd4 > [ 43.205791] [<ffffffc000093d70>] pci_common_init+0x274/0x378 > [ 43.210170] [<ffffffbff18e4b8c>] $x+0xb8c/0xc88 [pcie] > [ 43.214024] [<ffffffc00031013c>] platform_drv_probe+0x20/0x58 > [ 43.218483] [<ffffffc00030e6e4>] really_probe+0xc4/0x22c > [ 43.222510] [<ffffffc00030e958>] __driver_attach+0xa0/0xa8 > [ 43.226708] [<ffffffc00030cab0>] bus_for_each_dev+0x54/0x98 > [ 43.231000] [<ffffffc00030e234>] driver_attach+0x1c/0x28 > [ 43.235024] [<ffffffc00030deb0>] bus_add_driver+0x14c/0x204 > [ 43.239309] [<ffffffc00030f038>] driver_register+0x64/0x130 > [ 43.243598] [<ffffffc000310110>] __platform_driver_register+0x5c/0x68 > [ 43.248757] [<ffffffc0003101b4>] platform_driver_probe+0x28/0xac > [ 43.253485] [<ffffffbff18e4cb8>] pcie_init+0x30/0x3c [pcie] > [ 43.258293] [<ffffffc0000815dc>] do_one_initcall+0x88/0x19c > [ 43.262585] [<ffffffc0000f6b74>] load_module+0xc2c/0xf2c > [ 43.266609] [<ffffffc0000f6fd0>] SyS_finit_module+0x78/0x88 > [ 43.270897] ---[ end trace ea5eb60837afb5aa ]--- > > Reported-by: Zhang Jukuo <zhangjukuo@xxxxxxxxxx> > Tested-by: Zhang Jukuo <zhangjukuo@xxxxxxxxxx> > Signed-off-by: Yijing Wang <wangyijing@xxxxxxxxxx> I applied this to pci/msi for v3.20, thanks! I reworked the changelog as follows; let me know if it still doesn't make things clear: commit 6a878e5085fe97bd1e222b7883a1b815fcbbe4ed Author: Yijing Wang <wangyijing@xxxxxxxxxx> Date: Wed Jan 28 09:52:17 2015 +0800 PCI: Fail MSI-X mappings if there's no space assigned to MSI-X BAR Unlike MSI, which is configured via registers in the MSI capability in Configuration Space, MSI-X is configured via tables in Memory Space. These MSI-X tables are mapped by a device BAR, and if no Memory Space has been assigned to the BAR, MSI-X cannot be used. Fail MSI-X setup if no space has been assigned for the BAR. Previously, we ioremapped the MSI-X table even if the resource hadn't been assigned. In this case, the resource address is undefined (and is often zero), which may lead to warnings or oopses in this path: pci_enable_msix msix_capability_init msix_map_region ioremap_nocache The PCI core sets resource flags to zero when it can't assign space for the resource (see reset_resource()). There are also some cases where it sets the IORESOURCE_UNSET flag, e.g., pci_reassigndev_resource_alignment(), pci_assign_resource(), etc. So we must check for both cases. [bhelgaas: changelog] Reported-by: Zhang Jukuo <zhangjukuo@xxxxxxxxxx> Tested-by: Zhang Jukuo <zhangjukuo@xxxxxxxxxx> Signed-off-by: Yijing Wang <wangyijing@xxxxxxxxxx> Signed-off-by: Bjorn Helgaas <bhelgaas@xxxxxxxxxx> diff --git a/arch/x86/pci/xen.c b/arch/x86/pci/xen.c index c489ef2c1a39..34fc4189ebf0 100644 --- a/arch/x86/pci/xen.c +++ b/arch/x86/pci/xen.c @@ -298,12 +298,16 @@ static int xen_initdom_setup_msi_irqs(struct pci_dev *dev, int nvec, int type) map_irq.entry_nr = nvec; } else if (type == PCI_CAP_ID_MSIX) { int pos; + unsigned long flags; u32 table_offset, bir; pos = dev->msix_cap; pci_read_config_dword(dev, pos + PCI_MSIX_TABLE, &table_offset); bir = (u8)(table_offset & PCI_MSIX_TABLE_BIR); + flags = pci_resource_flags(dev, bir); + if (!flags || (flags & IORESOURCE_UNSET)) + return -EINVAL; map_irq.table_base = pci_resource_start(dev, bir); map_irq.entry_nr = msidesc->msi_attrib.entry_nr; diff --git a/drivers/pci/msi.c b/drivers/pci/msi.c index fd60806d3fd0..c3e7dfcf9ff5 100644 --- a/drivers/pci/msi.c +++ b/drivers/pci/msi.c @@ -694,11 +694,16 @@ static void __iomem *msix_map_region(struct pci_dev *dev, unsigned nr_entries) { resource_size_t phys_addr; u32 table_offset; + unsigned long flags; u8 bir; pci_read_config_dword(dev, dev->msix_cap + PCI_MSIX_TABLE, &table_offset); bir = (u8)(table_offset & PCI_MSIX_TABLE_BIR); + flags = pci_resource_flags(dev, bir); + if (!flags || (flags & IORESOURCE_UNSET)) + return NULL; + table_offset &= PCI_MSIX_TABLE_OFFSET; phys_addr = pci_resource_start(dev, bir) + table_offset; _______________________________________________ Xen-devel mailing list Xen-devel@xxxxxxxxxxxxx http://lists.xen.org/xen-devel
|
Lists.xenproject.org is hosted with RackSpace, monitoring our |