[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Xen-devel] [PATCH OSSTEST 05/12] Add and expose some testsupport APIs



> -----Original Message-----
> From: Ian Jackson [mailto:Ian.Jackson@xxxxxxxxxxxxx]
> Sent: Wednesday, February 11, 2015 10:54 PM
> To: Hu, Robert
> Cc: xen-devel@xxxxxxxxxxxxx; jfehlig@xxxxxxxx; wei.liu2@xxxxxxxxxx;
> ian.campbell@xxxxxxxxxx; Pang, LongtaoX
> Subject: Re: [PATCH OSSTEST 05/12] Add and expose some testsupport APIs
> 
> Robert Ho writes ("[PATCH OSSTEST 05/12] Add and expose some testsupport
> APIs"):
> > When install L2 guest, we will need to invoke  'select_ether' to get
> > guest MAC address. So here expose select_ether().
> 
> I'm not sure whether you actually need to do this.  I will look at the rest of
> your series to see why prepareguest() isn't suitable.  But this part of the 
> patch
> is fine in principle.
> 
> > And
> 
> These seem like two indepenedent patches.  They should be split up.
> 
> >  also, we added another function 'guest_editconfig_cd' and expose it.
> >   This function bascically changes guest boot device sequence and
> > alter its on_reboot behavior to restart.
> 
> I don't understand why guest_editconfig_nocd isn't sufficient.
> 
After finishing L1 guest VM installation, we need to change L1 guest boot 
sequence from ISO image to hard disk, 
so we will edit the "boot=cd" in hvm configure file and we added 
'guest_editconfig_cd'. But, guest_editconfig_nocd could not get
this point.
> Ian.

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel


 


Rackspace

Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.