Re: [Xen-devel] [PATCH] Do not assume mtu the mtu of xnb and mtu interfaces on FreeBSD.

[Ian Campbell <ian.campbell@xxxxxxxxxx>]

On Mon, 2015-04-20 at 12:21 +0200, Gustau PÃrez wrote:
> 
> On 20/04/2015 12:01, Wei Liu wrote:
> > On Mon, Apr 20, 2015 at 11:25:36AM +0200, Roger Pau Monnà wrote:
> >> El 20/04/15 a les 9.12, Gustau Perez ha escrit:
> >>> On creation time, tap and xnb interfaces are created with an mtu of
> >>> 1500 bytes, assuming the bridge will have the same value.
> >>> Instead, check the bridge mtu and configure the new xnb or
> >>> tap interface with the same value.
> >>>
> >>> The tools used are sed and ifconfig, both included on base. No need
> >>> to install additional ports (no new dependences).
> >>>
> >>> Signed-off-by: Gustau Perez <gustau.perez@xxxxxxxxx>
> >> Acked-by: Roger Pau Monnà <roger.pau@xxxxxxxxxx>
> >>
> >> +CCing the tools maintainers.
> >>
> > The patch title is a bit cryptic. Maybe change it to:
> >
> >   hotplug: set network interface MTU to bridge MTU on FreeBSD
> >
> > ?
> >
> > In any case
> >
> > Acked-by: Wei Liu <wei.liu2@xxxxxxxxxx>
> >
> > Wei.
> 
>    Seems fine to me.

I went with "hotplug/FreeBSD: set network interface MTU to bridge MTU".
Acked + applied, thanks.

> 
>    Best,
> 
>    G.



_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel