Re: [Xen-devel] [PATCH] xen/arm: gic-hip04: Resync the driver with the GICv2

[Zoltan Kiss <zoltan.kiss@xxxxxxxxxx>]

On 01/06/15 13:11, Julien Grall wrote:
> On 01/06/15 12:25, Zoltan Kiss wrote:
> > Hi,
> >
> > Yes, we managed to test it, and it works. Then only thing I've found is
> > this bit:
> >
> > +    /* Only 1020 interrupts are supported */
> > +    gicv2_info.nr_lines = min(1020U, nr_lines);
> >
> > This interrupt controller only supports 511, so 1020 should be replaced.
> > We had such checking in the code in the early versions, and I looked
> > everywhere in the archives to figure out why it was dropped before
> > upstreaming, but I couldn't find it.
> I'm aware of the 512 limit (see comment on the patch [1]). This change
> was introduced on GICv2/GICv3 because the nr_lines will always be
> aligned to 32, although IRQ 1020-1023 are reserved.
>
> 512 is a multiple of 32 and unless you have reserved IRQ below 512
> and/or your GIC doesn't expose the right number of IRQ, this doesn't
> harm and keep the change limited.
>
> > Other than this bit:
> >
> > Reviewed-by: Zoltan Kiss <zoltan.kiss@xxxxxxxxxx>
> > Tested-by: Shameerali Kolothum Thodi <shameerali.kolothum.thodi@xxxxxxxxxx>
> Thanks. Can I get some Acked/Review on the other pending patch series?
>
> http://lists.xenproject.org/archives/html/xen-devel/2015-05/msg00944.html :
> 6 patches to ack.
Sure. Btw. do you have them in a public repo somewhere? It would make it 
a little bit easier to apply and test.
> Regards,
>
> [1] https://patches.linaro.org/46100/
_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel