[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Xen-devel] [PATCH v5 7/9] x86/intel_pstate: add a booting param to select the driver to load



On 14/09/2015 19:18,  Jan Beulich wrote:
>>> On 14.09.15 at 04:42, <wei.w.wang@xxxxxxxxx> wrote:
> By default, the old P-state driver (acpi-freq) is used. Adding 
> "intel_pstate" to the Xen booting param list to enable the use of 
> intel_pstate. However, if intel_pstate is enabled on a machine which 
> does not support the driver (e.g. Nehalem), the old P-state driver 
> will be loaded due to the failure loading of intel_pstate.
> 
> Also, adding the intel_pstate booting parameter to 
> xen-command-line.markdown.
> 
> Signed-off-by: Wei Wang <wei.w.wang@xxxxxxxxx>
> ---

> Was this a resend? Without any note it's unclear whether the earlier or later 
> one with the same title should be looked at.

I just didn't see this one appearing in the mailing list, so I re-sent the  
[PATCH v5 7/9] separately. Sorry about the confusion.

Best,
Wei


_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel


 


Rackspace

Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.