Re: [Xen-devel] [PATCH v2 01/16] Xen: ACPI: Hide UART used by Xen

[Stefano Stabellini <stefano.stabellini@xxxxxxxxxxxxx>]

On Mon, 18 Jan 2016, Mark Rutland wrote:
> On Fri, Jan 15, 2016 at 02:55:14PM +0800, Shannon Zhao wrote:
> > From: Shannon Zhao <shannon.zhao@xxxxxxxxxx>
> > 
> > ACPI 6.0 introduces a new table STAO to list the devices which are used
> > by Xen and can't be used by Dom0. On Xen virtual platforms, the physical
> > UART is used by Xen. So here it hides UART from Dom0.
> > 
> > Signed-off-by: Shannon Zhao <shannon.zhao@xxxxxxxxxx>
> > ---
> > CC: "Rafael J. Wysocki" <rjw@xxxxxxxxxxxxx> (supporter:ACPI)
> > CC: Len Brown <lenb@xxxxxxxxxx> (supporter:ACPI)
> > CC: linux-acpi@xxxxxxxxxxxxxxx (open list:ACPI)
> > ---
> >  drivers/acpi/bus.c | 30 ++++++++++++++++++++++++++++++
> >  1 file changed, 30 insertions(+)
> > 
> > diff --git a/drivers/acpi/bus.c b/drivers/acpi/bus.c
> > index a212cef..d7a559f 100644
> > --- a/drivers/acpi/bus.c
> > +++ b/drivers/acpi/bus.c
> > @@ -46,6 +46,7 @@ ACPI_MODULE_NAME("bus");
> >  struct acpi_device *acpi_root;
> >  struct proc_dir_entry *acpi_root_dir;
> >  EXPORT_SYMBOL(acpi_root_dir);
> > +static u64 spcr_uart_addr;
> >  
> >  #ifdef CONFIG_X86
> >  #ifdef CONFIG_ACPI_CUSTOM_DSDT
> > @@ -93,6 +94,17 @@ acpi_status acpi_bus_get_status_handle(acpi_handle 
> > handle,
> >  {
> >     acpi_status status;
> >  
> > +   if (spcr_uart_addr != 0xffffffffffffffff) {
> 
> The SPCR spec says that the Base Address fields being zero means that
> console redirection is disabled (though I'm not clear on whether or not
> that requires the whole acpi_generic_address to be zero).
> 
> Can we not use that here?

Shannon changed the code from 0 to 0xffffffffffffffff following my
suggestion to his previous series, but I didn't realize that the SPCR
spec says 0 means no console redirection. In that case using 0 is
better.

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel