Re: [Xen-devel] run xen on hikey board

[Julien Grall <julien.grall@xxxxxxx>]

On 14/04/2016 12:39, Safa Hamza wrote:
> hello
Hello,

>   to build xen on hikey board ..only should i write
>
> make dist-xen XEN_TARGET_ARCH=arm64 CROSS_COMPILE=aarch64-linux-gnu-
>
>
>
> there is no CONFIG_EARLY_PRINTK like other board (omap5432 , cubie ..)
Nobody adds earlyprintk support for the hikey board. Feel free to send a 
patch for it.
However, CONFIG_EARLY_PRINTK should not be necessary unless you are 
trying to debug early boot.
Regards,

--
Julien Grall

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel