[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Xen-devel] [PATCH] arm/acpi: Add Server Base System Architecture UART support

On 30/05/2016 13:00, Stefano Stabellini wrote:
On Fri, 27 May 2016, Julien Grall wrote:
Hello Shanker,

On 27/05/16 15:01, Shanker Donthineni wrote:
On 05/27/2016 08:04 AM, Julien Grall wrote:
On 27/05/16 01:28, Shanker Donthineni wrote:
The ARM Server Base System Architecture describes a generic UART
interface. It doesn't support clock control registers to set
baudrate. So, extend the driver probe() to handle SBSA interface
types and set the baudrate to 115200 for SBSA interfaces.

I cannot find any mention of the baudrate in the SBSA. Where does it come

Yes, no where mentioned about the baudrate in SBSA document. I used 115200
based on the  the Linux  PL011 driver.

Looking at the Linux code, it is a default when there is no valid
configuration (which may not be suitable for any platform?).

Whilst Linux userspace cares about the baudrate, Xen only use it to configure
the hardware. Given that the UART should have been configured by the
hardware-specific software, the proper value should be BAUD_AUTO.

If you look at the code, pl011_init_preirq will read the baud rate when
uart->baud == BAUD_AUTO but will never be used after.

The problem is that IBRD and FBRD are not part of the SBSA doc, so to
make the driver compliant, we would have to skip reading the baudrate
too, which shouldn't be a problem.

Well, we are reading the baud rate, but it is never used within the driver except. So I would drop the code rather than skip it.


Julien Grall

Xen-devel mailing list



Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.