[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Xen-devel] Unable to boot Xen 4.7-rc4 on HiKey



Hi Tamas,

On 02/06/16 02:09, Tamas K Lengyel wrote:
On Wed, Jun 1, 2016 at 3:49 PM, Julien Grall <julien.grall@xxxxxxx> wrote:
On 01/06/2016 18:10, Tamas K Lengyel wrote:

Hi all,
following the steps from http://wiki.xen.org/wiki/HiKey I'm unable to
get the board to boot Xen. I'm using the Debian reference image from
linaro as base
(https://builds.96boards.org/releases/hikey/linaro/debian/latest/)
and that boots fine both from the SD card directly and through
startup.nsh. However, when I try to boot Xen I see only the following:

Xen 4.7.0-rc (c/s Mon May 23 12:07:20 2016 +0100 git:8478c94-dirty) EFI
loader
Using configuration file 'xen.cfg'
Image: 0x000000007a121000-0x000000007acb8a70

After that no output and dom0 never comes online on the network
either. I tried compiling Xen on the device itself in case it was a
problem with my cross-compile setup but no difference. Also with and
without debug=y. Any tips on what might be going wrong here?


I gave a quick look at the upstream device-tree of the hikey, the path
/smb/uart@f7113000.

If you use the upstream device-tree, it should be able to find the correct
UART via "stdout-path" and therefore dtuart=... should not be necessary.

Let me know if it works for you, and I will update the wiki page.

No, I removed the dtuart=... part from xen.cfg but there is no
difference in the output and dom0 never comes up on the network
either.

Which device-tree are you using?

Regards,

--
Julien Grall

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel

 


Rackspace

Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.