Re: [Xen-devel] [PATCH v12 00/10] x86: multiboot2 protocol support

[Konrad Rzeszutek Wilk <konrad.wilk@xxxxxxxxxx>]

On Fri, Jan 20, 2017 at 02:42:30PM -0500, Doug Goldstein wrote:
> On 1/19/17 8:34 PM, Daniel Kiper wrote:
> > Hi,
> > 
> > I am sending twelfth version of multiboot2 protocol support for
> > legacy BIOS and EFI platforms. This patch series release contains
> > fixes for all known/confirmed issues.
> 
> With my fix to efi_multiboot2() in 5/10 and the entire series applied, I
> get the following on some of the systems I have access to:
> 
> (XEN) [    2.000533] HVM: HAP page sizes: 4kB, 2MB, 1GB
> (XEN) [    7.012109] Stuck ??
> (XEN) [    7.012129] Failed to bring up CPU 1 (error -5)
> (XEN) [   12.023606] Stuck ??
> (XEN) [   12.023622] Failed to bring up CPU 2 (error -5)
> (XEN) [   17.035099] Stuck ??
> (XEN) [   17.035115] Failed to bring up CPU 3 (error -5)
> (XEN) [   17.035116] Brought up 1 CPUs
> 
> On other machines they reset when setting PAGING into cr0 (actually the
> jmp following it) on line 124 of trampoline.S
> 
> If I drop the series to just 2-5 against staging (since patch 1 has
> already gone in) and apply the fix to efi_multiboot2() then all the
> machines I presently have access to boot.
> 
> Effectively the fix to efi_multiboot2() gets us back to the same level
> of hardware support that v11 + my v5 was at for 1-5. So I will extend my:
> 
> Reviewed-by: Doug Goldstein <cardoe@xxxxxxxxxx>
> Tested-by: Doug Goldstein <cardoe@xxxxxxxxxx>
> 
> on the condition that the fix is applied to 5/10 prior to commit.

I am assuming you had applied this fix on top of this version? If
so any chance you could reply here with it - just to make sure
that nothing is lost?

Thanks!

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
https://lists.xen.org/xen-devel