[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Xen-devel] Error in Xen while booting for salvator-X (M3 Board)



Hi,

PFA the DTS I use for M3ULCB board


On 02/27/2017 12:48 PM, Oleksandr Tyshchenko wrote:
Hi.

On Mon, Feb 27, 2017 at 12:29 PM, George John <georgeeldhojohn@xxxxxxxxx> wrote:
Hi,
Thanks for the reply,
I am using Linux version 4.6.
The memory nodes were already squashed. When I have used a different version
of Xen, it booted to dom0. but still the crash occurs as shown in the log
below.

I have also noticed that for salvator x M3 board(r8a7796) the dtb file used
was r8a7795-salvator-x-dom0.dtb
Is it ok?
I don't know about M3 board.
CC my colleague who plays with M3 board. Hope, that he can shed some lights.

regards,
George

On Fri, Feb 24, 2017 at 8:43 PM, Oleksandr Tyshchenko <olekstysh@xxxxxxxxx>
wrote:
Hi,

Not 100% sure, but anyway...

Can you recheck after squashing all memory nodes to a single one.

---
I guess, you have following in your device tree:

memory@48000000 {
device_type = "memory";
/* first 128MB is reserved for secure area. */
reg = <0x0 0x48000000 0x0 0x38000000>;
};

memory@500000000 {
device_type = "memory";
reg = <0x5 0x00000000 0x0 0x40000000>;
};

memory@600000000 {
device_type = "memory";
reg = <0x6 0x00000000 0x0 0x40000000>;
};

memory@700000000 {
device_type = "memory";
reg = <0x7 0x00000000 0x0 0x40000000>;
};

---
Try to make next:

memory@48000000 {
device_type = "memory";
/* first 128MB is reserved for secure area. */
reg = <0x0 0x48000000 0x0 0x38000000>,
      <0x5 0x00000000 0x0 0x40000000>,
      <0x6 0x00000000 0x0 0x40000000>,
      <0x7 0x00000000 0x0 0x40000000>;
};



On Fri, Feb 24, 2017 at 4:53 PM, Julien Grall <julien.grall@xxxxxxx>
wrote:

On 21/02/17 12:03, George John wrote:
Hi,

Hello,


I was trying out xen in salvator-X(M3 Board as described
in

https://wiki.xenproject.org/wiki/Xen_ARM_with_Virtualization_Extensions/Salvator-X

I ran in to following error:


U-Boot 2015.04 (Feb 21 2017 - 14:24:48)

CPU: Renesas Electronics R8A7796 rev 1.0
Board: Salvator-X
I2C:   ready
DRAM:  3.9 GiB
MMC:   sh-sdhi: 0, sh-sdhi: 1, sh-sdhi: 2
In:    serial
Out:   serial
Err:   serial
Net:   Board Net Initialization Failed
No ethernet found.
Hit any key to stop autoboot:  0
819584 bytes read in 89 ms (8.8 MiB/s)
64927 bytes read in 23 ms (2.7 MiB/s)
14038016 bytes read in 1188 ms (11.3 MiB/s)
10319 bytes read in 19 ms (530.3 KiB/s)
## Booting kernel from Legacy Image at 48080000 ...
    Image Name:   XEN
    Image Type:   AArch64 Linux Kernel Image (uncompressed)
    Data Size:    819520 Bytes = 800.3 KiB
    Load Address: 78080000
    Entry Point:  78080000
    Verifying Checksum ... OK
## Flattened Device Tree blob at 48000000
    Booting using the fdt blob at 0x48000000
    Loading Kernel Image ... OK
    Using Device Tree in place at 0000000048000000, end 0000000048012d9e

Starting kernel ...

- UART enabled -
- CPU 00000000 booting -
- Current EL 00000008 -
- Xen starting at EL2 -
- Zero BSS -
- Setting up control registers -
- Turning on paging -
- Ready -
(XEN) Checking for initrd in /chosen
(XEN) RAM: 0000000048000000 - 000000007fffffff
(XEN) RAM: 0000000500000000 - 000000053fffffff
(XEN) RAM: 0000000600000000 - 000000063fffffff
(XEN) RAM: 0000000700000000 - 000000073fffffff
(XEN)
(XEN) MODULE[0]: 0000000048000000 - 0000000048010000 Device Tree
(XEN) MODULE[1]: 000000007a000000 - 000000007c000000 Kernel
(XEN) MODULE[2]: 000000007c000000 - 000000007c010000 XSM
(XEN)  RESVD[0]: 0000000048000000 - 0000000048010000
(XEN)
(XEN) Command line: dom0_mem=512M console=dtuart dtuart=serial0
dom0_max_vcpus=1 bootscrub=0 flask_enforcing=1
(XEN) Placing Xen at 0x000000007fe00000-0x0000000080000000
(XEN) Update BOOTMOD_XEN from 0000000078080000-0000000078196e01 =>
000000007fe00000-000000007ff16e01

Which kernel version is it?






After this, it hangs. What could be the possible reason?

Xen will initialize the heap and then continue into the boot. I would
add
more debug around setup_mm to see where it failed.

Regards,

--
Julien Grall

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
https://lists.xen.org/xen-devel


--
Regards,

Oleksandr Tyshchenko




Attachment: r8a7796-m3ulcb-dom0.dts
Description: Text document

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
https://lists.xen.org/xen-devel

 


Rackspace

Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.