[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Xen-devel] [PATCH] vt-d: use two 32-bit writes to update DMAR fault address registers



The 64-bit DMAR fault address is composed of two 32 bits registers
DMAR_FEADDR_REG and DMAR_FEUADDR_REG. According to VT-d spec:
"Software is expected to access 32-bit registers as aligned doublewords",
a hypervisor should use two 32-bit writes to DMAR_FEADDR_REG and
DMAR_FEUADDR_REG separately in order to update a 64-bit fault address,
rather than a 64-bit write to DMAR_FEADDR_REG.

Though I haven't seen any errors caused by such one 64-bit write on
real machines, it's still better to follow the specification.

Signed-off-by: Haozhong Zhang <haozhong.zhang@xxxxxxxxx>
---
 xen/drivers/passthrough/vtd/iommu.c | 4 +++-
 1 file changed, 3 insertions(+), 1 deletion(-)

diff --git a/xen/drivers/passthrough/vtd/iommu.c 
b/xen/drivers/passthrough/vtd/iommu.c
index daaed0abbd..067c092214 100644
--- a/xen/drivers/passthrough/vtd/iommu.c
+++ b/xen/drivers/passthrough/vtd/iommu.c
@@ -1105,7 +1105,9 @@ static void dma_msi_set_affinity(struct irq_desc *desc, 
const cpumask_t *mask)
 
     spin_lock_irqsave(&iommu->register_lock, flags);
     dmar_writel(iommu->reg, DMAR_FEDATA_REG, msg.data);
-    dmar_writeq(iommu->reg, DMAR_FEADDR_REG, msg.address);
+    dmar_writel(iommu->reg, DMAR_FEADDR_REG, msg.address_lo);
+    if (x2apic_enabled)
+        dmar_writel(iommu->reg, DMAR_FEUADDR_REG, msg.address_hi);
     spin_unlock_irqrestore(&iommu->register_lock, flags);
 }
 
-- 
2.11.0


_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
https://lists.xen.org/xen-devel

 


Rackspace

Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.