Re: [Xen-devel] [PATCH v4] x86/nmi: start NMI watchdog on CPU0 after SMP bootstrap

["Jan Beulich" <JBeulich@xxxxxxxx>]

>>> On 19.02.18 at 18:51, <igor.druzhinin@xxxxxxxxxx> wrote:
> We're noticing a reproducible system boot hang on certain
> Skylake platforms where the BIOS is configured in legacy
> boot mode with x2APIC disabled. The system stalls immediately
> after writing the first SMP initialization sequence into APIC ICR.
> 
> The cause of the problem is watchdog NMI handler execution -
> somewhere near the end of NMI handling (after it's already
> rescheduled the next NMI) it tries to access IO port 0x61
> to get the actual NMI reason on CPU0. Unfortunately, this
> port is emulated by BIOS using SMIs and this emulation for
> some reason takes more time than we expect during INIT-SIPI-SIPI
> sequence. As the result, the system is constantly moving between
> NMI and SMI handler and not making any progress.
> 
> To avoid this, initialize the watchdog after SMP bootstrap on
> CPU0 and, additionally, protect the NMI handler by moving
> IO port access before NMI re-scheduling. The latter should also
> help in case of post boot CPU onlining. Although we're running
> watchdog at much lower frequency at this point, it's neveretheless
> possible we may trigger the issue anyway.
> 
> Signed-off-by: Igor Druzhinin <igor.druzhinin@xxxxxxxxxx>

Reviewed-by: Jan Beulich <jbeulich@xxxxxxxx>



_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxxx
https://lists.xenproject.org/mailman/listinfo/xen-devel