[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [Xen-devel] [RFC PATCH v2 01/12] include/linux/gfp.h: get rid of GFP_ZONE_TABLE/BAD
From: Huaisheng Ye <yehs1@xxxxxxxxxx> Replace GFP_ZONE_TABLE and GFP_ZONE_BAD with encoded zone number. Delete ___GFP_DMA, ___GFP_HIGHMEM and ___GFP_DMA32 from GFP bitmasks, the bottom three bits of GFP mask is reserved for storing encoded zone number. The encoding method is XOR. Get zone number from enum zone_type, then encode the number with ZONE_NORMAL by XOR operation. The goal is to make sure ZONE_NORMAL can be encoded to zero. So, the compatibility can be guaranteed, such as GFP_KERNEL and GFP_ATOMIC can be used as before. Reserve __GFP_MOVABLE in bit 3, so that it can continue to be used as a flag. Same as before, __GFP_MOVABLE respresents movable migrate type for ZONE_DMA, ZONE_DMA32, and ZONE_NORMAL. But when it is enabled with __GFP_HIGHMEM, ZONE_MOVABLE shall be returned instead of ZONE_HIGHMEM. __GFP_ZONE_MOVABLE is created to realize it. With this patch, just enabling __GFP_MOVABLE and __GFP_HIGHMEM is not enough to get ZONE_MOVABLE from gfp_zone. All subsystems should use GFP_HIGHUSER_MOVABLE directly to achieve that. Decode zone number directly from bottom three bits of flags in gfp_zone. The theory of encoding and decoding is, A ^ B ^ B = A Suggested-by: Matthew Wilcox <willy@xxxxxxxxxxxxx> Signed-off-by: Huaisheng Ye <yehs1@xxxxxxxxxx> Cc: Andrew Morton <akpm@xxxxxxxxxxxxxxxxxxxx> Cc: Vlastimil Babka <vbabka@xxxxxxx> Cc: Michal Hocko <mhocko@xxxxxxxx> Cc: Mel Gorman <mgorman@xxxxxxxxxxxxxxxxxxx> Cc: Kate Stewart <kstewart@xxxxxxxxxxxxxxxxxxx> Cc: "Levin, Alexander (Sasha Levin)" <alexander.levin@xxxxxxxxxxx> Cc: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx> --- include/linux/gfp.h | 98 ++++++----------------------------------------------- 1 file changed, 11 insertions(+), 87 deletions(-) diff --git a/include/linux/gfp.h b/include/linux/gfp.h index 1a4582b..ab0fb7f 100644 --- a/include/linux/gfp.h +++ b/include/linux/gfp.h @@ -16,9 +16,7 @@ */ /* Plain integer GFP bitmasks. Do not use this directly. */ -#define ___GFP_DMA 0x01u -#define ___GFP_HIGHMEM 0x02u -#define ___GFP_DMA32 0x04u +#define ___GFP_ZONE_MASK 0x07u #define ___GFP_MOVABLE 0x08u #define ___GFP_RECLAIMABLE 0x10u #define ___GFP_HIGH 0x20u @@ -53,11 +51,15 @@ * without the underscores and use them consistently. The definitions here may * be used in bit comparisons. */ -#define __GFP_DMA ((__force gfp_t)___GFP_DMA) -#define __GFP_HIGHMEM ((__force gfp_t)___GFP_HIGHMEM) -#define __GFP_DMA32 ((__force gfp_t)___GFP_DMA32) +#define __GFP_DMA ((__force gfp_t)OPT_ZONE_DMA ^ ZONE_NORMAL) +#define __GFP_HIGHMEM ((__force gfp_t)OPT_ZONE_HIGHMEM ^ ZONE_NORMAL) +#define __GFP_DMA32 ((__force gfp_t)OPT_ZONE_DMA32 ^ ZONE_NORMAL) #define __GFP_MOVABLE ((__force gfp_t)___GFP_MOVABLE) /* ZONE_MOVABLE allowed */ -#define GFP_ZONEMASK (__GFP_DMA|__GFP_HIGHMEM|__GFP_DMA32|__GFP_MOVABLE) +#define GFP_ZONEMASK ((__force gfp_t)___GFP_ZONE_MASK | ___GFP_MOVABLE) +/* bottom 3 bits of GFP bitmasks are used for zone number encoded*/ +#define __GFP_ZONE_MASK ((__force gfp_t)___GFP_ZONE_MASK) +#define __GFP_ZONE_MOVABLE \ + ((__force gfp_t)(ZONE_MOVABLE ^ ZONE_NORMAL) | ___GFP_MOVABLE) /* * Page mobility and placement hints @@ -279,7 +281,7 @@ #define GFP_DMA __GFP_DMA #define GFP_DMA32 __GFP_DMA32 #define GFP_HIGHUSER (GFP_USER | __GFP_HIGHMEM) -#define GFP_HIGHUSER_MOVABLE (GFP_HIGHUSER | __GFP_MOVABLE) +#define GFP_HIGHUSER_MOVABLE (GFP_USER | __GFP_ZONE_MOVABLE) #define GFP_TRANSHUGE_LIGHT ((GFP_HIGHUSER_MOVABLE | __GFP_COMP | \ __GFP_NOMEMALLOC | __GFP_NOWARN) & ~__GFP_RECLAIM) #define GFP_TRANSHUGE (GFP_TRANSHUGE_LIGHT | __GFP_DIRECT_RECLAIM) @@ -326,87 +328,9 @@ static inline bool gfpflags_allow_blocking(const gfp_t gfp_flags) #define OPT_ZONE_DMA32 ZONE_NORMAL #endif -/* - * GFP_ZONE_TABLE is a word size bitstring that is used for looking up the - * zone to use given the lowest 4 bits of gfp_t. Entries are GFP_ZONES_SHIFT - * bits long and there are 16 of them to cover all possible combinations of - * __GFP_DMA, __GFP_DMA32, __GFP_MOVABLE and __GFP_HIGHMEM. - * - * The zone fallback order is MOVABLE=>HIGHMEM=>NORMAL=>DMA32=>DMA. - * But GFP_MOVABLE is not only a zone specifier but also an allocation - * policy. Therefore __GFP_MOVABLE plus another zone selector is valid. - * Only 1 bit of the lowest 3 bits (DMA,DMA32,HIGHMEM) can be set to "1". - * - * bit result - * ================= - * 0x0 => NORMAL - * 0x1 => DMA or NORMAL - * 0x2 => HIGHMEM or NORMAL - * 0x3 => BAD (DMA+HIGHMEM) - * 0x4 => DMA32 or DMA or NORMAL - * 0x5 => BAD (DMA+DMA32) - * 0x6 => BAD (HIGHMEM+DMA32) - * 0x7 => BAD (HIGHMEM+DMA32+DMA) - * 0x8 => NORMAL (MOVABLE+0) - * 0x9 => DMA or NORMAL (MOVABLE+DMA) - * 0xa => MOVABLE (Movable is valid only if HIGHMEM is set too) - * 0xb => BAD (MOVABLE+HIGHMEM+DMA) - * 0xc => DMA32 (MOVABLE+DMA32) - * 0xd => BAD (MOVABLE+DMA32+DMA) - * 0xe => BAD (MOVABLE+DMA32+HIGHMEM) - * 0xf => BAD (MOVABLE+DMA32+HIGHMEM+DMA) - * - * GFP_ZONES_SHIFT must be <= 2 on 32 bit platforms. - */ - -#if defined(CONFIG_ZONE_DEVICE) && (MAX_NR_ZONES-1) <= 4 -/* ZONE_DEVICE is not a valid GFP zone specifier */ -#define GFP_ZONES_SHIFT 2 -#else -#define GFP_ZONES_SHIFT ZONES_SHIFT -#endif - -#if 16 * GFP_ZONES_SHIFT > BITS_PER_LONG -#error GFP_ZONES_SHIFT too large to create GFP_ZONE_TABLE integer -#endif - -#define GFP_ZONE_TABLE ( \ - (ZONE_NORMAL << 0 * GFP_ZONES_SHIFT) \ - | (OPT_ZONE_DMA << ___GFP_DMA * GFP_ZONES_SHIFT) \ - | (OPT_ZONE_HIGHMEM << ___GFP_HIGHMEM * GFP_ZONES_SHIFT) \ - | (OPT_ZONE_DMA32 << ___GFP_DMA32 * GFP_ZONES_SHIFT) \ - | (ZONE_NORMAL << ___GFP_MOVABLE * GFP_ZONES_SHIFT) \ - | (OPT_ZONE_DMA << (___GFP_MOVABLE | ___GFP_DMA) * GFP_ZONES_SHIFT) \ - | (ZONE_MOVABLE << (___GFP_MOVABLE | ___GFP_HIGHMEM) * GFP_ZONES_SHIFT)\ - | (OPT_ZONE_DMA32 << (___GFP_MOVABLE | ___GFP_DMA32) * GFP_ZONES_SHIFT)\ -) - -/* - * GFP_ZONE_BAD is a bitmap for all combinations of __GFP_DMA, __GFP_DMA32 - * __GFP_HIGHMEM and __GFP_MOVABLE that are not permitted. One flag per - * entry starting with bit 0. Bit is set if the combination is not - * allowed. - */ -#define GFP_ZONE_BAD ( \ - 1 << (___GFP_DMA | ___GFP_HIGHMEM) \ - | 1 << (___GFP_DMA | ___GFP_DMA32) \ - | 1 << (___GFP_DMA32 | ___GFP_HIGHMEM) \ - | 1 << (___GFP_DMA | ___GFP_DMA32 | ___GFP_HIGHMEM) \ - | 1 << (___GFP_MOVABLE | ___GFP_HIGHMEM | ___GFP_DMA) \ - | 1 << (___GFP_MOVABLE | ___GFP_DMA32 | ___GFP_DMA) \ - | 1 << (___GFP_MOVABLE | ___GFP_DMA32 | ___GFP_HIGHMEM) \ - | 1 << (___GFP_MOVABLE | ___GFP_DMA32 | ___GFP_DMA | ___GFP_HIGHMEM) \ -) - static inline enum zone_type gfp_zone(gfp_t flags) { - enum zone_type z; - int bit = (__force int) (flags & GFP_ZONEMASK); - - z = (GFP_ZONE_TABLE >> (bit * GFP_ZONES_SHIFT)) & - ((1 << GFP_ZONES_SHIFT) - 1); - VM_BUG_ON((GFP_ZONE_BAD >> bit) & 1); - return z; + return ((__force unsigned int)flags & __GFP_ZONE_MASK) ^ ZONE_NORMAL; } /* -- 1.8.3.1 _______________________________________________ Xen-devel mailing list Xen-devel@xxxxxxxxxxxxxxxxxxxx https://lists.xenproject.org/mailman/listinfo/xen-devel
|
Lists.xenproject.org is hosted with RackSpace, monitoring our |