Re: [Xen-devel] [PATCH v5 0/10] arm: more kconfig configurability and small default configs

["Jan Beulich" <JBeulich@xxxxxxxx>]

>>> On 05.06.18 at 19:52, <julien.grall@xxxxxxx> wrote:

> 
> On 04/06/18 18:23, Stefano Stabellini wrote:
>> Hi all,
>> 
>> This patch series is the first step toward building a small certifiable
>> Xen hypervisor for ARM boards.
>> 
>> First, the series makes a few changes to allow disabling more kconfig
>> options: most of them already exist but cannot be disabled.
>> 
>> Then, it introduces a reference kconfig for Renesas RCar (due to popular
>> demand, candidate for certifications), Xilinx MPSoC, and for QEMU
>> aarch64 (not for certifications, but useful for debugging).
>> 
>> The last patch in the series adds a convenient cloc target to count the
>> total lines of code of the source files built.
>> 
>> As a consequence of these changes, some options will become user-visible
>> and not dependent on CONFIG_EXPERT. It does not mean that Xen Project
>> will security support all possible combinations of kconfig options.
>> Instead, there will be a small set of pre-canned configurations that
>> will be supported.  See: https://marc.info/?l=xen-devel&m=152424389512432 
> 
> George, Ian, Jan, shall SUPPORT.MD be updated to reflect the Kconfig 
> changes?
> 
> I am mostly thinking about the board support and the fact that more 
> options on Arm are selectable by the users.

I think that would be very desirable, yes.

Jan



_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxxx
https://lists.xenproject.org/mailman/listinfo/xen-devel