[Xen-devel] [PATCH MM-PART2 v2 09/19] xen/arm64: head: Correctly report the HW CPU ID

[Julien Grall <julien.grall@xxxxxxx>]

There are no reason to consider the HW CPU ID will be 0 when the
processor is part of a uniprocessor system. At best, this will result to
conflicting output as the rest of Xen use the value directly read from
MPIDR_EL1.

So remove the zeroing and logic to check if the CPU is part of a
uniprocessor system.

Signed-off-by: Julien Grall <julien.grall@xxxxxxx>
Reviewed-by: Andrii Anisov <andrii_anisov@xxxxxxxx>

---
    Changes in v2:
        - Add Andrii's reviewed-by
---
 xen/arch/arm/arm64/head.S | 6 ------
 1 file changed, 6 deletions(-)

diff --git a/xen/arch/arm/arm64/head.S b/xen/arch/arm/arm64/head.S
index b957eb90fb..08094a273e 100644
--- a/xen/arch/arm/arm64/head.S
+++ b/xen/arch/arm/arm64/head.S
@@ -277,15 +277,9 @@ GLOBAL(init_secondary)
         mov   x26, #1                /* X26 := skip_zero_bss */
 
 common_start:
-        mov   x24, #0                /* x24 := CPU ID. Initialy zero until we
-                                      * find that multiprocessor extensions are
-                                      * present and the system is SMP  */
         mrs   x0, mpidr_el1
-        tbnz  x0, _MPIDR_UP, 1f      /* Uniprocessor system? */
-
         ldr   x13, =(~MPIDR_HWID_MASK)
         bic   x24, x0, x13           /* Mask out flags to get CPU ID */
-1:
 
         /* Non-boot CPUs wait here until __cpu_up is ready for them */
         cbz   x22, 1f
-- 
2.11.0


_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxxx
https://lists.xenproject.org/mailman/listinfo/xen-devel