Re: [Xen-devel] [PATCH v2 0/2] Raspberry Pi 4 support

[Julien Grall <julien.grall@xxxxxxx>]

Hi Stewart,

On 29/07/2019 14:19, Stewart Hildebrand wrote:
> This is a series to enable UART console for Raspberry Pi 4. Note that I'm 
> relying on the firmware to initialize the UART (i.e. enable_uart=1 in 
> config.txt), since full UART initialization on this platform requires accessing 
> some registers outside the range specified in the brcm,bcm2835-aux-uart node.
>
> I have been able to get Xen+dom0+domUs booting. Tested with Xen 4.12 and 
> 4.13-unstable (b4c8a27d5b) and Linux 4.19.y (Raspberry Pi linux tree + a couple 
> of patches). Please see [1] for build instructions and limitations.
>
> New in v2:
> * Drop early printk alias
> * Set reg-shift and reg-io-width in the Xen driver
> * Blacklist other aux peripherals in platform settings (spi1, spi2, and a 
> couple of base aux registers)
>
> Thanks,
> Stewart Hildebrand
> DornerWorks, Ltd
>
> [1] https://github.com/dornerworks/xen-rpi4-builder
>
> Stewart Hildebrand (2):
>    ns16550: Add compatible string for Raspberry Pi 4
I have committed this patch...

>    xen/arm: platform: Add Raspberry Pi platform
... this one need an answer regarding the impact on blacklist spi1 and spi2.

Cheers,

--
Julien Grall

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxxx
https://lists.xenproject.org/mailman/listinfo/xen-devel