Re: [Xen-devel] [TESTDAY] Test report

[Jürgen Groß <jgross@xxxxxxxx>]

On 16.11.19 02:12, Roman Shaposhnik wrote:
> NOTE: this may or may not be a hair on fire problem, reporting it
> anyway since I'd hate to pass on something that maybe a serious issue.
> I haven't had time to debug this just yet -- so just reporting it here
> pretty raw.
>
> Software:
>     Xen 4.13 RC2
>     Linux kernel 4.19.5
> Hardware:
>     Supermicro E300
>         https://www.supermicro.com/en/products/system/Mini-ITX/SYS-E300-8D.cfm
>     Supermicro E100
>         https://www.supermicro.com/en/products/system/Box_PC/SYS-E100-9S.cfm
>     Supermicro E50
>         https://www.supermicro.com/en/products/system/Box_PC/SYS-E50-9AP.cfm
>
> Functionality tested: trying to boot Dom0
> Comments: Xen boots completely and then seems like it either dies
> right after saying
>      Xen relinquishing a console
> or Dom0 dies (without printing a single line of output)
>
> FWIW, this started happening after upgrade to RC2. IOW, if I take my
> previous RC1 binary and stick it into the very same setup --
> everything boots fine.
>
> The issue doesn't seem to be reproducible on Dell boxes (and in my
> virtual QEmu setup) that I've got.
Can you please add the following to dom0's boot parameters:

console=hvc0 earlyprintk=xen

and send the Xen boot log (obtained via serial line)?


Juergen

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxxx
https://lists.xenproject.org/mailman/listinfo/xen-devel