Re: [Xen-devel] [PATCH 2/4] xenbus: limit when state is forced to closed

["Durrant, Paul" <pdurrant@xxxxxxxxxx>]

> -----Original Message-----
> From: Roger Pau Monné <roger.pau@xxxxxxxxxx>
> Sent: 09 December 2019 11:39
> To: Durrant, Paul <pdurrant@xxxxxxxxxx>
> Cc: linux-kernel@xxxxxxxxxxxxxxx; xen-devel@xxxxxxxxxxxxxxxxxxxx; Juergen
> Gross <jgross@xxxxxxxx>; Stefano Stabellini <sstabellini@xxxxxxxxxx>;
> Boris Ostrovsky <boris.ostrovsky@xxxxxxxxxx>
> Subject: Re: [Xen-devel] [PATCH 2/4] xenbus: limit when state is forced to
> closed
> 
> On Thu, Dec 05, 2019 at 02:01:21PM +0000, Paul Durrant wrote:
> > Only force state to closed in the case when the toolstack may need to
> > clean up. This can be detected by checking whether the state in xenstore
> > has been set to closing prior to device removal.
> 
> I'm not sure I see the point of this, I would expect that a failure to
> probe or the removal of the device would leave the xenbus state as
> closed, which is consistent with the actual driver state.
> 
> Can you explain what's the benefit of leaving a device without a
> driver in such unknown state?
> 

If probe fails then I think it should leave the state alone. If the state is 
moved to closed then basically you just killed that connection to the guest (as 
the frontend will normally close down when it sees this change) so, if the 
probe failure was due to a bug in blkback or, e.g., a transient resource issue 
then it's game over as far as that guest goes.
The ultimate goal here is PV backend re-load that is completely transparent to 
the guest. Modifying anything in xenstore compromises that so we need to be 
careful.

  Paul

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxxx
https://lists.xenproject.org/mailman/listinfo/xen-devel