Re: [Xen-devel] [PATCH v2 2/4] xenbus: limit when state is forced to closed

[Roger Pau Monné <roger.pau@xxxxxxxxxx>]

On Tue, Dec 10, 2019 at 11:33:45AM +0000, Paul Durrant wrote:
> If a driver probe() fails then leave the xenstore state alone. There is no
> reason to modify it as the failure may be due to transient resource
> allocation issues and hence a subsequent probe() may succeed.
> 
> If the driver supports re-binding then only force state to closed during
> remove() only in the case when the toolstack may need to clean up. This can
> be detected by checking whether the state in xenstore has been set to
> closing prior to device removal.
> 
> NOTE: Re-bind support is indicated by new boolean in struct xenbus_driver,
>       which defaults to false. Subsequent patches will add support to
>       some backend drivers.

My intention was to specify whether you want to close the
backends on unbind in sysfs, so that an user can decide at runtime,
rather than having a hardcoded value in the driver.

Anyway, I'm less sure whether such runtime tunable is useful at all,
so let's leave it out and can always be added afterwards. At the end
of day a user wrongly doing a rmmod blkback can always recover
gracefully by loading blkback again with your proposed approach to
leave connections open on module removal.

Sorry for the extra work.

Thanks, Roger.

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxxx
https://lists.xenproject.org/mailman/listinfo/xen-devel