Re: [Xen-devel] [PATCH v2] arm64: xen: Use modern annotations for assembly functions

[Stefano Stabellini <sstabellini@xxxxxxxxxx>]

On Thu, 9 Jan 2020, Catalin Marinas wrote:
> On Wed, Jan 08, 2020 at 03:55:52PM +0000, Will Deacon wrote:
> > On Thu, Dec 19, 2019 at 01:07:50PM -0800, Stefano Stabellini wrote:
> > > On Thu, 19 Dec 2019, Mark Brown wrote:
> > > > In an effort to clarify and simplify the annotation of assembly 
> > > > functions
> > > > in the kernel new macros have been introduced. These replace ENTRY and
> > > > ENDPROC. Update the annotations in the xen code to the new macros.
> > > > 
> > > > Signed-off-by: Mark Brown <broonie@xxxxxxxxxx>
> > > > Reviewed-by: Julien Grall <julien@xxxxxxx>
> > > > Reviewed-by: Stefano Stabellini <sstabellini@xxxxxxxxxx>
> > > 
> > > Thank you!
> > > 
> > > > ---
> > > >  arch/arm64/xen/hypercall.S | 8 ++++----
> > > >  1 file changed, 4 insertions(+), 4 deletions(-)
> > 
> > Is this going via the Xen tree, or shall I queue it along with the other
> > asm annotation patches in the arm64 tree? I don't see it in -next yet.
> 
> Since it has been reviewed by the Xen maintainers, just queue it via the
> arm64 tree.

Yes, that's fine by me

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxxx
https://lists.xenproject.org/mailman/listinfo/xen-devel