Re: [RFC PATCH v3 6/6] of: Add plumbing for restricted DMA pool

[Florian Fainelli <f.fainelli@xxxxxxxxx>]

On 1/14/21 1:08 AM, Claire Chang wrote:
> On Wed, Jan 13, 2021 at 7:48 AM Florian Fainelli <f.fainelli@xxxxxxxxx> wrote:
>>
>> On 1/5/21 7:41 PM, Claire Chang wrote:
>>> If a device is not behind an IOMMU, we look up the device node and set
>>> up the restricted DMA when the restricted-dma-pool is presented.
>>>
>>> Signed-off-by: Claire Chang <tientzu@xxxxxxxxxxxx>
>>> ---
>>
>> [snip]
>>
>>> +int of_dma_set_restricted_buffer(struct device *dev)
>>> +{
>>> +     struct device_node *node;
>>> +     int count, i;
>>> +
>>> +     if (!dev->of_node)
>>> +             return 0;
>>> +
>>> +     count = of_property_count_elems_of_size(dev->of_node, "memory-region",
>>> +                                             sizeof(phandle));
>>
>> You could have an early check for count < 0, along with an error
>> message, if that is deemed useful.
>>
>>> +     for (i = 0; i < count; i++) {
>>> +             node = of_parse_phandle(dev->of_node, "memory-region", i);
>>> +             if (of_device_is_compatible(node, "restricted-dma-pool"))
>>
>> And you may want to add here an of_device_is_available(node). A platform
>> that provides the Device Tree firmware and try to support multiple
>> different SoCs may try to determine if an IOMMU is present, and if it
>> is, it could be marking the restriced-dma-pool region with a 'status =
>> "disabled"' property, or any variant of that scheme.
> 
> This function is called only when there is no IOMMU present (check in
> drivers/of/device.c). I can still add of_device_is_available(node)
> here if you think it's helpful.

I believe it is, since boot loader can have a shared Device Tree blob
skeleton and do various adaptations based on the chip (that's what we
do) and adding a status property is much simpler than insertion new
nodes are run time.

> 
>>
>>> +                     return of_reserved_mem_device_init_by_idx(
>>> +                             dev, dev->of_node, i);
>>
>> This does not seem to be supporting more than one memory region, did not
>> you want something like instead:
>>
>>                 ret = of_reserved_mem_device_init_by_idx(...);
>>                 if (ret)
>>                         return ret;
>>
> 
> Yes. This implement only supports one restriced-dma-pool memory region
> with the assumption that there is only one memory region with the
> compatible string, restricted-dma-pool, in the dts. IIUC, it's similar
> to shared-dma-pool.

Then if here is such a known limitation it should be both documented and
enforced here, you shouldn ot be iterating over all of the phandles that
you find, stop at the first one and issue a warning if count > 1?
-- 
Florian