[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] Re: Regression with CET: [PATCH v1] x86/mm: avoid inadvertently degrading a TLB flush to local only
On 27.04.2022 20:44, David Vrabel wrote: > > > On 27/04/2022 19:03, Andrew Cooper wrote: >> On 19/04/2022 16:03, David Vrabel wrote: >>> From: David Vrabel <dvrabel@xxxxxxxxxxxx> >>> >>> If the direct map is incorrectly modified with interrupts disabled, >>> the required TLB flushes are degraded to flushing the local CPU only. >>> >>> This could lead to very hard to diagnose problems as different CPUs will >>> end up with different views of memory. Although, no such issues have yet >>> been identified. >>> >>> Change the check in the flush_area() macro to look at system_state >>> instead. This defers the switch from local to all later in the boot >>> (see xen/arch/x86/setup.c:__start_xen()). This is fine because >>> additional PCPUs are not brought up until after the system state is >>> SYS_STATE_smp_boot. >>> >>> Signed-off-by: David Vrabel <dvrabel@xxxxxxxxxxxx> >> >> This explodes on CET systems: >> >> (XEN) Assertion 'local_irq_is_enabled()' failed at arch/x86/smp.c:265 >> (XEN) ----[ Xen-4.17.0-10.24-d x86_64 debug=y Not tainted ]---- >> (XEN) CPU: 0 >> (XEN) RIP: e008:[<ffff82d040345300>] flush_area_mask+0x40/0x13e >> <snip> >> (XEN) Xen call trace: >> (XEN) [<ffff82d040345300>] R flush_area_mask+0x40/0x13e >> (XEN) [<ffff82d040338a40>] F modify_xen_mappings+0xc5/0x958 >> (XEN) [<ffff82d0404474f9>] F >> arch/x86/alternative.c#_alternative_instructions+0xb7/0xb9 >> (XEN) [<ffff82d0404476cc>] F alternative_branches+0xf/0x12 >> (XEN) [<ffff82d04044e37d>] F __start_xen+0x1ef4/0x2776 >> (XEN) [<ffff82d040203344>] F __high_start+0x94/0xa0 >> (XEN) >> (XEN) >> (XEN) **************************************** >> (XEN) Panic on CPU 0: >> (XEN) Assertion 'local_irq_is_enabled()' failed at arch/x86/smp.c:265 >> (XEN) **************************************** >> (XEN) >> >> We really did want a local-only flush here, because we specifically >> intended to make self-modifying changes before bringing secondary CPUs up. > > I think the transition to SYS_STATE_smp_boot system state should be > later. i.e., the last point were only 1 PCPU is guaranteed. I'm not sure there isn't code which assumes pre-SMP initcalls to happen in this state already. So it may take addition of yet another state if no other solution can be found. Additionally, how would you mean to deal with the PV shim case then, which continues to be running UP quite a bit further? Jan
|
Lists.xenproject.org is hosted with RackSpace, monitoring our |