[Xen-users] multiple ips for veth?

[Roger Keays <roger.keays@xxxxxxxxxxxxxxxxxx>]

Hi,

Is it possible to configure a domU with multiple IP addresses?

i.e. (v)eth0 and (v)eth0:0, or (v)eth0 and lo:0

I can add the additional interface in the domU just fine so that it 
shows up in ifconfig, but the bridge doesn't seem to do its magic to 
make it accessible.
vif = [ 'bridge=xenbr0', 'bridge=xenbr0' ]

The docs tend to indicate that vifx.1 will always go to (v)eth1, but 
unfortunately I can't get the bridge to do (v)eth1 either :(
Thanks in advance,

Roger

--
----------------------------------------
Ninth Avenue Software
p: +61 7 3870 8494 (UTC +10)
f: +61 7 3870 8491
w: http://www.ninthavenue.com.au
e: info@xxxxxxxxxxxxxxxxxx
----------------------------------------


_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users