[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Xen-users] Re: multiple ips for veth?




Some output from the dom0 if its of any use:


[root@harrie xen]# brctl show
bridge name     bridge id               STP enabled     interfaces
xenbr0          8000.feffffffffff       no              peth0
                                                        vif0.0
                                                        vif2.0
                                                        vif2.1

[root@harrie xen]# ip ro
10.252.9.0/24 dev eth0  proto kernel  scope link  src 10.252.9.11
10.252.9.0/24 dev eth0  proto zebra  metric 10 equalize
169.254.0.0/16 dev eth0  scope link
default via 10.252.9.1 dev eth0

[root@harrie xen]# arp -na
? (10.252.9.1) at 00:04:96:20:AB:2A [ether] on eth0
? (10.252.9.12) at 00:16:3E:5F:26:4C [ether] on eth0


Roger Keays wrote:
Hi,

Is it possible to configure a domU with multiple IP addresses?

i.e. (v)eth0 and (v)eth0:0, or (v)eth0 and lo:0

I can add the additional interface in the domU just fine so that it shows up in ifconfig, but the bridge doesn't seem to do its magic to make it accessible.

vif = [ 'bridge=xenbr0', 'bridge=xenbr0' ]

The docs tend to indicate that vifx.1 will always go to (v)eth1, but unfortunately I can't get the bridge to do (v)eth1 either :(

Thanks in advance,

Roger



--
----------------------------------------
Ninth Avenue Software
p: +61 7 3870 8494 (UTC +10)
f: +61 7 3870 8491
w: http://www.ninthavenue.com.au
e: info@xxxxxxxxxxxxxxxxxx
----------------------------------------


_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users


 


Rackspace

Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.