Re: inet and brd for peth0 drops in setup_bridge_port() (Re: [Xen-users] Dom0 network problem)

["Christopher G. Stach II" <cgs@xxxxxxxxx>]

Matt Richardson wrote:
> I was having the same difficulty with Etch: networking was broken on
> Dom0 when using network-bridge, worked fine with network-dummy.
> However, I was just able to install a DomU using debootstrap with
> network-dummy selected, then had to switch to network-bridge and
> restart xend to get networking happening for both.  ifconfig  on Dom0
> shows fe:ff:blah MAC addresses for the bridge, vif, and peth
> interfaces, which seems odd to me.  It also seems odd that networking
> for Dom0 only works when a DomU is brought up.  But I'm new to this,
> so a lot of it seems odd.
> 

What state was networking left in when the script ran?  Were the
interfaces in t

-- 
Christopher G. Stach II


_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users