[Xen-users] switch to static ip

[Marco Mandl <marco.mandl@xxxxxx>]

Hello,

I migrated a sarge installation into a domU. I did this using dhcp. That
worked fine.

But now I want to switch to static ip address.

In the corresponding xmdomain.cfg I change:
#dhcp = 'dhcp'
#vif  = [ '' ]
dhcp = "off"
ip = "192.168.17.16"
netmask = "255.255.255.0"
#broadcast = "192.168.17.255"
#network = "192.168.17.0"
gateway = "192.168.17.1"

I even tried to changed the /etc/network/interfaces of the domU:
auto lo
iface lo inet loopback
auto eth0
iface eth0 inet static
name Ethernet LAN card
address 192.168.17.16
netmask 255.255.255.0
broadcast 192.168.17.255
network 192.168.17.0
gateway 192.168.17.1
## The primary network interface
#auto eth0
#iface eth0 inet dhcp
## post-up ethtool -K eth0 tx off

But there is no eth0 in domU:
$ sudo ifconfig -s
Iface   MTU Met   RX-OK RX-ERR RX-DRP RX-OVR   TX-OK TX-ERR TX-DRP TX-OVR Flg
lo    16436 0      1461      0      0      0    1461      0      0      0 LRU

Network of dom0 seems to be ok:
# ifconfig -s
Iface   MTU Met   RX-OK RX-ERR RX-DRP RX-OVR   TX-OK TX-ERR TX-DRP TX-OVR Flg
eth0   1500 0     42285      0      0      0    34822      0      0      0 BMRU
lo    16436 0         0      0      0      0        0      0      0      0 LRU
peth0  1500 0     43014      0      0      0    35866      0      0      0 BORU
vif0.  1500 0     34822      0      0      0    42285      0      0      0 BORU
xenbr  1500 0       342      0      0      0        0      0      0      0 BORU


What am I doing wrong?

Regards,
Marco



_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users