[Xen-users] xm console/vnc HVM problems

["Hu Jia Yi" <jyhu@xxxxxxxxx>]

Hi, I installed and ran a winxp HVM using virt-manager successfully.
Now I tried to run it using xm command line but encountered a few
problems. 

The procedure is as follows.
When I ran "xm start winxp" without the -p, the winxp domain should be
running. But the info in virt-manager showed it being paused. Then I
pressed "Ctrl + C" so that I could key-in next command "xm unpause
winxp". After this unpause command, the winxp was running without any
domain console coming out. So I input "xm console winxp", nothing
happened. I already enable vnc=1 and vncconsole=1.

My questions are:
1. Why the domain would pause even when I hadn't tell it to pause?
2. When I input a command such as "xm start winxp", I cannot input any
other command untill I press "Ctrl + C", is it normal or should I
reconfigure something?
3. How can I see the domain console after I start running it?

Best regards,
Hu Jia Yi
Ext: 20430
Tel: 65-67510430


_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users