[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Xen-users] network consistency



b52@xxxxxxxxx wrote:
I have a host system with two bridges br10 and br20 and I would like to
connect a domU to both of them.
Is there any way to make sure domU ethX is always connected to dom0 br10
and domU ethY is always connected to dom0 br20?
You should be able to pass a bridge in the vif parameter, for example:

vif ['bridge=br10']

Yes, but will
   vif = [ 'bridge=br10', 'bridge=br20' ]
always connect domU-eth>0< with br10 and domU-eth>1< with br20 or might
this ocasionally swap?
So is the first vif parameter always interface eth0 and the second always
eth1?

Yes, so far from experience I have see that the first parameter would always be eth0, second eth1 and third eth2. So if you specify,

vif = [ "mac=00:16:3e:7b:0e:a4,bridge=br10,script=vif-bridge","mac=00:16:3e:7b:0e:a9,bridge=br20,script=vif-bridge" ]

eth0 would be bind to br10 and eth1 to br20.

And beside, is there a way to rename the interfacenames inside the domU
from outside? e.g. the vif script will create a myint1 and myint2
interface inside the domU?

AFAIK, no. I am not sure though about paravirtualized guests.

--Sadique

Thanks, Holger

Or even better, is it possible to rename the domU interfaces to a
corresponding name with xen from outside? (I don't want to use udev
inside
the domU for that)

Thank you.

Cheers,
Holger



_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users



_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users


 


Rackspace

Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.