In my case upgrade Xen 3.2.1-rc5 to 3.2.1 at F8 Dom0 (64-bit)
did allow to put virt-install from F8 repos in work and create CentOS 5.1
DomU . Installer ran just fine (DHCP DomU configuration).
However, created <Domain> been viewed in "xm list"
output hanged during reboot and appeared to be unmanageable by xm.
1. xm start <Domain> hangs
2. xm console <Domain> hangs
online_vcpus gets zerroed at attempt to start <Domain>.
Domain also was brought into paused state.
xm unpause <Domain> didn't help much.
Daemons xenstored,xenconsoled,bpkctrl were running exactly as on Xen 3.1.2 F8 Dom0.
Just in case , i also activated service xendomains with no luck
Thank you.
Boris.
29/08, amazab@xxxxxxxx <amazab@xxxxxxxx> wrote:
From: amazab@xxxxxxxx <amazab@xxxxxxxx>
Subject: Re: [Xen-users] Virt-install not working
To: "Alain Barthe" <ab266061@xxxxxxxxx>, xen-users@xxxxxxxxxxxxxxxxxxx
Date: Thursday, May 29, 2008, 12:39 PM
It worked, Thanks Alain.
However, I still have further problems:
1- I still cannot get "Virtual Machine Manager" to work, I feel it is
another configurations problem
2- I created a domain using the "xm create <domain name>" then
I just shut
it down. When I do "xm start <domain name>" it says
"<domain name> does
not exist". How can I get xm to recognize previously created domains.
3- How can I see the Xen logs from Dom-0. Where are they saved? Is there a
specific toold to see events that occur in the hypervisor during the real
time?
Ahmed
> With xen 3.0, the parameter "xend-unix-server" must be set to
"yes" in
> the
> /etc/xen/xend-config.sxp configuration file for virt-manager and
> virt-install to work. It is set to "no" by default. Maybe it is
the same
> with xen 3.2.
>
> Hope this helps.
>
> Alain Barthe
>
> 2008/5/29 <amazab@xxxxxxxx>:
>
>> Hi all,
>>
>> I installed Xen 3.2.1 on FC8 from the source, It is working fine and I
>> even created a virtual machine, however I cannot use the "Virtual
>> Machine
>> Manager" it does not even respond and when I try to use
virt-install, I
>> get the message:
>>
>> Traceback (most recent call last):
>> File "/usr/sbin/virt-install", line 502, in <module>
>> main()
>> File "/usr/sbin/virt-install", line 345, in main
>> conn = cli.getConnection(options.connect)
>> File "/usr/lib/python2.5/site-packages/virtinst/cli.py",
line 76, in
>> getConnection
>> return libvirt.open(connect)
>> File "/usr/lib/python2.5/site-packages/libvirt.py", line
135, in open
>> if ret is None:raise libvirtError('virConnectOpen()
failed')
>> libvirtError: virConnectOpen() failed
>>
>>
>> Thanks In Advance,
>> Ahmed
>>
>> _______________________________________________
>> Xen-users mailing list
>> Xen-users@xxxxxxxxxxxxxxxxxxx
>> http://lists.xensource.com/xen-users
>>
>
_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users | 
