|
Same issue here - I'm running 0.9.11-pre7 and my network cards do not pick up an IP address. I boot w/o the /gplpv switch and the RTL-based interface works fine.
-Nick
>>> On 2008/07/14 at 13:07, "Steffen Heil" <lists@xxxxxxxxxxxxxxx> wrote:
Hi
I had installed the gpl-pv drivers 0.9.11-pre5 installed and had the
following problem:
All drivers seemed to work correctly, but the network card never received
any packet.
Now I have updated to 0.9.11-pre7, but the problem persists.
I cannot access the network at all, the incoming packet counter stays at 0.
I can only access it using the VNC console.
Can anyone give me a hint, what to try?
Regards,
Steffen
This e-mail may contain confidential and privileged material for the sole use of the intended recipient. If this email is not intended for you, or you are not responsible for the delivery of this message to the intended recipient, please note that this message may contain SEAKR Engineering (SEAKR) Privileged/Proprietary Information. In such a case, you are strictly prohibited from downloading, photocopying, distributing or otherwise using this message, its contents or attachments in any way. If you have received this message in error, please notify us immediately by replying to this e-mail and delete the message from your mailbox. Information contained in this message that does not relate to the business of SEAKR is neither endorsed by nor attributable to SEAKR.
|
