|
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [Xen-users] Re: to access 4 Virtual Hosts from a public IP
Thank you all It is working.I used IPTABLES.Each of the Virtual Host is connecting to internet now. On Sun, Apr 11, 2010 at 7:56 PM, Jason Edgecombe <jason@xxxxxxxxxxxxxxxxx> wrote: > Tapas Mishra wrote: >> >> On Sat, Apr 10, 2010 at 10:50 PM, Jason Edgecombe >> <jason@xxxxxxxxxxxxxxxxx> wrote: >> >>> >>> ok, I'm a little confused. Please confirm that I understand this >>> correctly. >>> >>> You have 6 hosts: >>> >> >> Right >> >>> >>> two physical machines: A( xenhost dom0) & B (non-xen) >>> >> >> Right >> >>> >>> four xen domU's: a,b,c,d >>> >> >> Right >> >>> >>> You have two physical networks: Net1 (public internet), and Net2 (private >>> net) >>> >> >> Yes 2 networks >> >>> >>> Xen host A is connected to both Net1 and Net2. >>> >> >> Yes on same interface. >> >>> >>> Host A has a xen bridged >>> >> >> Yes now this is the problem wether bridge is running on it or not I am >> not sure although >> brctl show >> gives an out put bridge name eth2 >> but I am using xen 3.2 and in xen 3.3 and onwards the default name of >> bridge is same as >> the ethernet card. >> >> >>> >>> network with Net2, so that a, b, c, and d are all bridged to Net2. >>> >>> Host B is Net2. >>> >> >> >>> >>> Is this correct? >>> >> >> Yes >> >> Ok by the time you replied I had figured out see if it is right. >> Dom0 is acting as a router here >> as this page says >> dom0 from acting as an IP router: echo 0 > /proc/sys/net/ipv4/ip_forward. >> So the way I explained ssh is working from behind. >> >> Now the thing is I want to go to setup IPTABLES and NAT on Dom0 for >> the virtual hosts. >> I am very well aware of IPTABLES but Xen Dom0 is confusing me. >> I want these virtual hosts to be able to connect to internet as I run >> apt-get >> or commands so I will be creating a squid proxy on Dom0 for >> DomU's to be behind Dom0 is it possible if yes if you can provide me >> some link that may help me a bit. >> Xen network wiki page talks some thing about ebtables. >> http://ebtables.sourceforge.net/br_fw_ia/br_fw_ia.html >> Now here is I am confused at ebtables and iptables. >> > > You shouldn't need to use ebtables. Iptables should work. > > For your situation, you will need "echo 1 > /proc/sys/net/ipv4/ip_forward" > you should be able to to set up a bridge, but use the private NIC instead of > the public NIC on dom0., then just follow a NAT tutorial. > > Leave the ssh forwarding and apache proxy until last. > > Jason > -- Tapas +91 8971248477 _______________________________________________ Xen-users mailing list Xen-users@xxxxxxxxxxxxxxxxxxx http://lists.xensource.com/xen-users
|
 |
Lists.xenproject.org is hosted with RackSpace, monitoring our |