[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Xen-users] pfsense HVM network performance



This I did not do..

Is there a guide somewhere online?

Thanks

On 08/06/10 23:45, Dustin Marquess wrote:
Did you try recompiling the pfsense FreeBSD kernel using the XENHVM kernel config?  That way you'll get get PV drivers for network & disk I/O, which should help a lot.

-Dustin

On Tue, Jun 8, 2010 at 3:30 PM, Jonathan Tripathy <jonnyt@xxxxxxxxxxx> wrote:
Hi Everyone,

Just to let everyone know of my experience of network speed on pfsense HVM.

Initially, I started off by doing PCI passthrough for my WAN NIC, and used e1000 emulation for LAN. Speed was capping at 90Mbp/s.

When both were set to e1000, speed was capping at 30Mbp/s

When LAN was set to e1000 and WAN was set to default (rl8xxx), speed was capping at 71Mbp/s.

I wish I could have stayed with the first option, however my link speed is only detected at 10Mbps unless I take the cable out and in 2 or 3 times.

Any tips on the above? In some cases, to get the above speed, I had to enable "device polling" in pfsense

Thanks

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users

 


Rackspace

Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.