[Xen-users] XEN\Centos\Networking

[MHarran <martinharran@xxxxxxxxx>]

Iâve got a Hetzner EQ4 server running Centos in which I want to run a Linux VM (distro doesnât matter but probably Ubuntu) and a Windows 2008 VM (possibly 2 of latter).

I have installed XEN and can get a test Centos VM and a W2008 VM running okay in bridged mode but  Iâm seriously struggling to get routed networking up and running which I need so that I can access the machines directly using the extra IPâs that Hetzner have supplied.

The error Iâm getting is  "Error: Device 0 (vif) could not be connected. /etc/xen/scripts/vif-route failed; error detected." and my gut feeling is that this has something to do with the way the IPs are set up; although a seasoned Windows user,  Iâm still little more than a newbie to Linux so I may be making some fundamental errors here

First question is do the additional IPâs need to be set up before I do anything with the VMs? Iâve been following the tutorials here and here and they donât mention that but Iâm guessing that the server needs to know about the IPs before they can be used. I have tried setting them up using ifcfg-eth0:1, ifcfg-eth0:2, ifcfg-eth0:3 but they do not respond to ping.

When I change to routing, however, using the instructions here,  I cannot get the VMs to start, they return "Error: Device 0 (vif) could not be connected. /etc/xen/scripts/vif-route failed; error detected."

Iâm also confused about the settings to use for these IPâs. Hetzner have a funny way of issuing the additional IPâs, you have to request them individually which means you do not necessarily end up with contiguous addresses, here is what they gave me:

Main IP:
DEVICE=eth0
BOOTPROTO=static
BROADCAST=78.xx.xx.63
HWADDR=40:61:86:e9:d4:ae
IPADDR=78.xx.xx.55
NETMASK=255.255.255.255
SCOPE="peer 78.xx.x.33"

(Note: for some reason, I have written in my original notes that the Netmask should be 255.255.255.224 but 255.255.255.255 is what is showing after a reinstall. Could that be an error?)

The first additional IP is 78.xx.xx.45; I did not receive any instructions for that but I presume the netmask, and broadcast are the same.

My other two additional IPs are 178.nn.nn.157 and 178.nn.nn.157, i.e a completely different group.

The other details supplied for those two IPs are 
Gateway: 178.nn.nn.145
Mask: 255.255.255.240

As far as I can make out, in Xen networking, all the additional IPs should point to the main IP as their gateway so should I just ignore the gateway settings that Hetzner provided by email and set all the gateways to the main IP 78.xx.xx.55? Also, how to I treat the different netmaks in the two pairs of IP?

Final question - sorry for so many :) - is what is the significance of "SCOPE" in the main IP rather than GATEWAY?

--------------------------------------
*

Those instructions are actually for Debian but I've made the appropriate changes for Centos; I'm not that bothered about what distribution Dom0 runs on so I tried it with Debian, same problem with Error: Device 0 (vif) could not be connected...

---

View this message in context: XEN\Centos\Networking
Sent from the Xen - User mailing list archive at Nabble.com.

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users