[Xen-users] Xen bridge network

[radiogen Alex <radiogen@xxxxxx>]

I have installed Centos 5.5 + Xen. my server has two network cards: eth0 - for local trafic and eth1 - for global internet trafic. I have 5 usable IPs.  "ip ad" comand show the following eth1 addresses

eth1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue

    link/ether 00:25:90:30:78:a3 brd ff:ff:ff:ff:ff:ff

    inet xx.xx.xx.58/29 brd xx.xx.xx.63 scope global eth1

    inet xx.xx.xx.59/29 brd xx.xx.xx.63 scope global secondary eth1:0

    inet xx.xx.xx.60/29 brd xx.xx.xx.63 scope global secondary eth1:1

    inet xx.xx.xx.61/29 brd xx.xx.xx.63 scope global secondary eth1:2

    inet xx.xx.xx.62/29 brd xx.xx.xx.63 scope global secondary eth1:3

   

question is: 

how to use it correctly in XEN with bridge mode? and what to write in domU config file for vif = ["....."]

my xen-config.sxp setup

(network-script netwokr-bridge)

(vif-script vif-bridge)

for example if I use IP address xx.xx.xx.59 in windows it says address already in use.

thank you for any direction or if someone can post their setup for this type of network will help a lot!

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users